Radiator Swap - How Difficult????

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
forzaMC
E30 Zone Newbie
E30 Zone Newbie
Posts: 11
Joined: Fri Jun 17, 2005 11:00 pm
Location: Macclesfield

Post Fri Jul 29, 2005 5:15 pm

My Radiator has gone on my 320i G reg 6 pot manual, is it a difficult job to swap??

Cheers
Simon
E30 Zone Team Member
E30 Zone Team Member
Posts: 14939
Joined: Sun Jan 09, 2005 11:00 pm
Location: South Wales

Post Fri Jul 29, 2005 7:25 pm

Hi mate, it's a simple job, three hoses to remove, loosen the lower hose first, leave what coolant there is to escape come out, undo the 2 small nuts on the plastic holder on top of the rad, and lift out, refitting is the reversal of removal (Haynes anyone!?) refill with coolant/water to the correct mixture, and bleed the system too.
Image
User avatar
forzaMC
E30 Zone Newbie
E30 Zone Newbie
Posts: 11
Joined: Fri Jun 17, 2005 11:00 pm
Location: Macclesfield

Post Fri Jul 29, 2005 7:52 pm

Cheers Simon

Will give it a go tommoz
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49359
Joined: Mon Jan 10, 2005 11:00 pm

Post Fri Jul 29, 2005 10:11 pm

When you've finished and restart the car, make sure the heater is set to full heat, check that it begins to blow warm air as soon as you would expect it to, and watch the temp gauge.
These cars can airlock at the back of the head after the coolant has been drained, although not normally after just draiming the rad.