Mtech 1 kit??
Moderator: martauto
-
GoldenArms
- E30 Zone Newbie
- Posts: 179
- Joined: Tue Dec 04, 2007 11:00 pm
- Location: manchester
WILL A MTECH 1 KIT FIT ON A FACELIFT G REG 316i
-
jbh
- Hartge Crew
- Posts: 3963
- Joined: Sat Aug 11, 2007 11:00 pm
- Location: denny
it can be done but its a lot of work
-
zaust
- Zone day release
- Posts: 13007
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Somewhere in Hertfordshire , or press Ctrl + W
Get the angle grinder and wealder out.
M30 Tech 1 Touring on gas.
-
GoldenArms
- E30 Zone Newbie
- Posts: 179
- Joined: Tue Dec 04, 2007 11:00 pm
- Location: manchester
Forget that then . .cheers for replies. 
-
e30topless
- E30 Zone Team Member
- Posts: 13595
- Joined: Wed Aug 23, 2006 11:00 pm
- Location: surrounded by scrap
back bumper is fairly simple but for the front you need to change the valance for a pre-facelift one I have all the things needed to do this if you want them 
-
zaust
- Zone day release
- Posts: 13007
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Somewhere in Hertfordshire , or press Ctrl + W
Front bumper, valance and skirts are the easy bit fella, Just a few bolt's.e30topless wrote:back bumper is fairly simple but for the front you need to change the valance for a pre-facelift one I have all the things needed to do this if you want them
Rear bumper is why you need the angle grinder and wealder, As the length's of them (sides) are very different + the rear metal valance get's in the way of the tech 1 valance and stop's it fitting, Due to it sitting lower and also not even nearly fitting over the side's of the valance either.
M30 Tech 1 Touring on gas.
-
The_Diddler
- Love it up the more door !
- Posts: 3619
- Joined: Tue May 27, 2008 11:00 pm
- Location: Tamworth, Staffs Lovely!!!!!!
