Time-sert size time!!!

[rich318i]

Right not messing about now.

what size serts has everyone used with their M52/M54

M10x1.50x ???

No silly comments please about the race team and that TA

[leeparkes]

Serts?

[leeparkes]

Ah now i see...

http://www.timesert.com/

You not using an iron block?

[rich318i]

na fella m52 not a M20/M50 family

[Jimbob]

Say what. If you're sure the block has never been subject to overheating then give it a try without the timeserts surely?

[rich318i]

Say what. If you're sure the block has never been subject to overheating then give it a try without the timeserts surely?

I am.. just thinking ahead fella

[DanThe]

I used M16 because they are stronger innit

[rich318i]

20mm, 24.5mm or 30mm in length??

[maxfield]

Surely whoever is building your engine should be the ones sorting timeserts. They're the ones who have the engine in bits and can measure the threads etc. And also telling you if you even need them

[rich318i]

Surely whoever is building your engine should be the ones sorting timeserts. They're the ones who have the engine in bits and can measure the threads etc. And also telling you if you even need them

well as i said before just thinking ahead and like to know what sizes others have used in the past. Block is a non over heated job