m20 rebuild parts price please

[quinn_656]

hi
i was looking for a price for the following parts to rebuild my m20 b25

con rod bearing shells (standard)
main bearing shells (standard)
piston rings (standard)

top end gasket set (head, inlet, exhaust)
sump gasket

2no. dowels that locate the head onto the block

injector seals
front and rear crankshaft oil seals
intermediate shaft seal

timing belt
tensioner
water pump

324 td oil pump

my email address is william@quinnpiling.com

thanks

Willy

[Cotswoldbmw]

Hi Willy. Thanks for youe enquiry. We will need the last 7 digits of chassis no and also the colours marked on all bearings and sizes stamped on them to. Also any part numbers off them. Thanks.

regards

Paul.

[quinn_656]

hi paul

the engine im building is a 2.7 engine starting out with a 325i sport engine with a 525e crank and rods the engine is going into an e21 323i so the chassis no. wont be misleading

however the parts that i require should be the same as my mtec1 325i sport of which the last 7 digits are as follows:

0 858 273

there doesnt appear to be any colour or any referance to a colour on the existing bearings however the no.s stamped on the bearings are as follows:

connecting rod bearings
1284 849 & 850 an SK logo with 8578 Sd is also present
it appears that blue is for the top and red for the bottom that would mean i would require 6 blue and 6 red but i cant confirm this

the main bearing shells are still inside the block which is at the machine shop so i dont have access to it at the minute but i know that they will be the standard bearings

the pistons are standard sk 83.98mm

thanks

Willy

[Cotswoldbmw]

Morning Willy. Stuart has sent an email with the quotes on. Thanks.

regards

Paul.