Hi
Last weekend I tried to fit a set of braided brake hoses, did OK but only got 4 of the 6 on as two of the four rear ones are well hidden under the rear crossmember.
Does anyone have any tips for doing this or do I need some sort of special tool??
Cheers
Rob.
Rear Brake Lines
Moderator: martauto
- LeeInMontreal
- E30 Zone Newbie
- Posts: 7
- Joined: Sat Oct 14, 2006 11:00 pm
The trick is that because you will not use the old rubber lines, you can cut them as close to the steel fittings as possible. That will allow you to use a deep socket and an extension. Use your ratchet wrench to undo it. Much easier. 10 minutes per side.
Thanks all for that.
I think I may have one more go at it then get my local garage to do it if I fail...
I think I may have one more go at it then get my local garage to do it if I fail...
cheers, will let you all know how it turns out...