M technic II bodykit
Moderator: martauto
-
dannyboy3767
- E30 Zone Newbie

- Posts: 2
- Joined: Fri May 18, 2007 11:00 pm
hey lads new to this site, just bought a 1989 325i convertible and am looking for a nice kit for it i dont want big fibreglass bumbers, i really like the M techic style kit. I want the car looking like the convertible one at the top of the page can anyone please help me, im over in ireland here and its hard to find one. thanks lads and girls,
-
chinchilla
- E30 Zone Regular

- Posts: 743
- Joined: Mon Aug 21, 2006 11:00 pm
- Location: Cardiff!
The convertible at the top has the tech 1 kit with tech 2 spoiler. They come up for sale on the zone a few times, however the tech 1 cab skirts are very rare and hard to come by!
Put up a wanted thread and im sure you will find a tech 1 kit in no time!
Put up a wanted thread and im sure you will find a tech 1 kit in no time!
-
dannyboy3767
- E30 Zone Newbie

- Posts: 2
- Joined: Fri May 18, 2007 11:00 pm
there are bumpers on the cabrio at the mo i think there tech I bumpers though they have lines on the bottom of each bumper about 3 inches up from the bottom was looking for the newer look though. Someone must make them new????? If you boys in england dont knoe then nobody knows
Last edited by dannyboy3767 on Sat Jun 16, 2007 10:00 am, edited 1 time in total.
-
CHRISP
- Boost Junkie
- Posts: 714
- Joined: Thu Aug 18, 2005 11:00 pm
- Location: Wellington somerset
There is how to fit salon as cab tech 2 kit are like rocking horse s***
First turn the sill upside down, two inches in you will see a linemoulded ino the sill. Cut the sill at this point, this will stop the sill from kicking out.
Then turn it back up right there is a fixing part with two holes in that attaches to the front wing. When this part pushes against the wing it will try and hold the sill away from the car so cut the two edges of this clip which allows this part of the sill to bend forward, this will make it sit flush and look right.
First turn the sill upside down, two inches in you will see a linemoulded ino the sill. Cut the sill at this point, this will stop the sill from kicking out.
Then turn it back up right there is a fixing part with two holes in that attaches to the front wing. When this part pushes against the wing it will try and hold the sill away from the car so cut the two edges of this clip which allows this part of the sill to bend forward, this will make it sit flush and look right.

