Do you need to remove the bumper to remove the wing/fender?
Moderator: martauto
-
clydesdale
- E30 Zone Regular

- Posts: 296
- Joined: Fri Dec 30, 2005 11:00 pm
- Location: New York, USA
This is on a 1987 US 325is. I have the large chrome bumpers. I was considering removing the fender/wing to get to the scuttle vent drain. But, I have no interest in removing the bumper. Do you have to?
-
daimlerman
- **BANNED**
- Posts: 15968
- Joined: Mon Feb 27, 2006 11:00 pm
- Location: Grumpy Old Man
Afraid so!
Youth is wasted on the young.
-
clydesdale
- E30 Zone Regular

- Posts: 296
- Joined: Fri Dec 30, 2005 11:00 pm
- Location: New York, USA
Thanks man. The situation is worse than I thought. I am not even going to bother. I will have to come up with a bandaid repair for my rusted scuttle drain area.
-
Grrrmachine
- E30 Zone Wiki / Team Member

- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
I take it the fibreglass technique wasn't applicable then? For the sack of an extra 10 minutes an a $5 tool (Tork T55 bit for the bumper bolts) you're sacrificing an entire E30 to the Dreaded Rust.
