s50 itb's
Moderator: martauto
-
emdog16
- E30 Zone Regular
- Posts: 333
- Joined: Thu Mar 18, 2010 11:00 pm
- Location: Bicester Oxfordshire
Would the itb's from an s50 work on the m50? They both use a MAP sensor do they not? It should all bolt up in theory... Anyone done this/ looked into it?
Avid E30 Nut, and Scientist of all things that go BOiiiNGGGG.
If you want to go mental on your shocks... check out ForRacingUseOnly.com
If you want to go mental on your shocks... check out ForRacingUseOnly.com
-
Kos
- E30 Zone Team Member
- Posts: 15448
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: London / Cyprus
yes its been looked in to
no they wont work (not with out lots of work)
no they wont work (not with out lots of work)
-
emdog16
- E30 Zone Regular
- Posts: 333
- Joined: Thu Mar 18, 2010 11:00 pm
- Location: Bicester Oxfordshire
I take it they don't bolt up? I'm not afraid of fab/ electrical work.
Avid E30 Nut, and Scientist of all things that go BOiiiNGGGG.
If you want to go mental on your shocks... check out ForRacingUseOnly.com
If you want to go mental on your shocks... check out ForRacingUseOnly.com
-
Kos
- E30 Zone Team Member
- Posts: 15448
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: London / Cyprus
correct,emdog16 wrote:I take it they don't bolt up? I'm not afraid of fab/ electrical work.
the US m3 which was m50/m52 based used a single TB. the ins and outs of it i cant remember but if it was possible it would have been done, and i dont remember it ever being done
-
emdog16
- E30 Zone Regular
- Posts: 333
- Joined: Thu Mar 18, 2010 11:00 pm
- Location: Bicester Oxfordshire
however if I could make the TB's fit it should run, no?
Avid E30 Nut, and Scientist of all things that go BOiiiNGGGG.
If you want to go mental on your shocks... check out ForRacingUseOnly.com
If you want to go mental on your shocks... check out ForRacingUseOnly.com
-
Kos
- E30 Zone Team Member
- Posts: 15448
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: London / Cyprus
i'm sure it can, anything is possible