No star after engine rebuilt

[markus_74]

Hello,

I need help with some info.
I just rebuild my engine and now tried to start but engine can not turn on.

It is likely turn on a few second but then die and after that it won't start again.

There is spark at all sparkplugs, and there is a fuel at all injectors, so I think dme and cps is normal?

Injectors all firing fuel.

Does is it because the engine dead top is not in position?

Please help me what should I do

Thank you
Markus

It now run after I set the gap between cps with tooth 0.25mm

Sorry to write in the same first thread because the website not allowed me to reply, I don't know why


@tiggerfish
Thank you. It is not mixed as I have give it a label.

It run now but with full open throttle, I don't know why may be the engine still new so it need a few time to running in? As all parts still rough?

[TriggerFish]

Stupid suggestion, but it caught me out...

Are the tps and ICV plugged into the correct plugs? I got them mixed up, and it would start for a bit, then cut out immediately.