Hi.
I need to run my 2.0 up without using oil cooler. Can I just blank off the 2 fittings that would go to the original cooler or will I have to link the two together?
The car is standard, standard take off plate.
Many thanks.
Jon
M20 oil cooler take off.
Moderator: martauto
-
jimmyspeed
- E30 Zone Regular
- Posts: 848
- Joined: Sat Sep 08, 2007 11:00 pm
- Location: riding a wagon wheel west
a m20 2 litre does not have an oil cooler as standard - yours should have a filter that screws straight onto the block
if yours has an oil cooler from a 325i the thread are m22 x 1.5 - capping is not a good idea though
just get the parts of a standard 320i, its just a different filter and centre bolt
if yours has an oil cooler from a 325i the thread are m22 x 1.5 - capping is not a good idea though
just get the parts of a standard 320i, its just a different filter and centre bolt
-
HairyScreech
- Engaged to the E30 Zone
- Posts: 6265
- Joined: Sun Jan 21, 2007 11:00 pm
As above, you pretty much just remove the alu housing and then change the bolt/fitting the filter screws onto.
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
