Carpet out
Moderator: martauto
-
xavier
- E30 Zone Regular

- Posts: 743
- Joined: Thu May 29, 2008 11:00 pm
- Location: Western Australia
Does anyone know the steps invloved in taking out the carpets in a two door e30? I have heard that they need to be cut. Is this true? I am happy to spend a few days doing it if it means that i can take out the entire carpet. Can the rear parcel shelf carpet/lining under the rear window be removed? anyone tried to dye a beige one black?
-
leeparkes
- Married to the E30 Zone

- Posts: 9535
- Joined: Thu Jan 03, 2008 11:00 pm
- Location: Black country
The only place it needs to be cut is under the heater gubbins behind the centre console
Cypriotgeeza wrote:I done both my mates in my old 318is
felt so proud,even tried it with a E30 325i and got put in my place..
-
iceox
- E30 Zone Camper

- Posts: 1147
- Joined: Fri May 30, 2008 11:00 pm
- Location: Scottish Borders
once you start taking it out you'll see where it needs to be cut, make sure you take all the door trims etc off first becuase these will snap easy. if your taking it out completly you'll have to take the centre console off to.. taking the carpet out is just a pain in the ass if i'm honest

-
leeparkes
- Married to the E30 Zone

- Posts: 9535
- Joined: Thu Jan 03, 2008 11:00 pm
- Location: Black country
Even more of a pain in the arse getting them back in.
Cypriotgeeza wrote:I done both my mates in my old 318is
felt so proud,even tried it with a E30 325i and got put in my place..
-
poolnoodle
- E30 Zone Squatter

- Posts: 1785
- Joined: Sat May 24, 2008 11:00 pm
- Location: Hobart, Tasmania, Australia
I didn't think it was too much of a big job - a few things to remove though.
The cuts you need to make under the heater box will be well hidden and invisible once the console goes back in. You may also need to make a small cut around the steering column...again invisible afterwards.
So...remove - seats, front and rear console, plastic sill trims, kick panels, disconnect accelerator pedal. It is all pretty obvious once you get started.
Give the carpet a good cleaning with a hp water blaster when it's out. Amazing how well they come up after that treatment.
The cuts you need to make under the heater box will be well hidden and invisible once the console goes back in. You may also need to make a small cut around the steering column...again invisible afterwards.
So...remove - seats, front and rear console, plastic sill trims, kick panels, disconnect accelerator pedal. It is all pretty obvious once you get started.
Give the carpet a good cleaning with a hp water blaster when it's out. Amazing how well they come up after that treatment.
'83 Bronzit 323i (mmmm, chrome)
'74 Polaris 2002 (mmmm, retro)
'89 Delphin 535i (mmmm, waft waft)
'74 Polaris 2002 (mmmm, retro)
'89 Delphin 535i (mmmm, waft waft)
