I recetly bought som Z3, Z fx addetive and some Z8 protect
polished the car up with the Zfx and Z3 and it came up mint.
However, when i used the Z8 i read the instructions about not letting it dry and all that but when i tryd it it just cept smearing! i could get it so i looked good when you looked at it straight but then from the side or an angle it would look smeared again?
Any suggestions?
trouble using Zaino Z8
Moderator: martauto
very very fine mist
only do small area at a time
make sure you shake bottle well
only use a clean microfibre towel and keep turning cloth
only do say third of bonnet at a time
half a door etc
do not apply in sun or onto hot surface
it must be wiped straight away
if you do get smears then just reapply and rewipe
you only need the finest amount
john
only do small area at a time
make sure you shake bottle well
only use a clean microfibre towel and keep turning cloth
only do say third of bonnet at a time
half a door etc
do not apply in sun or onto hot surface
it must be wiped straight away
if you do get smears then just reapply and rewipe
you only need the finest amount
john
