Removing genuine Tech 1 bodykit

[Pad]

Evenin all.

Been a while since Ive been on here having sold my Tech2 325 Touring to Ian on the zone, but I coudnt keep away from e30s for long so Ive only gone and got a pukka Tech 1 sport.

Before I get all excited about the bargain I might have got, I need to get the kit off to get a good look.

Question is, where are all the fixings?! Side skirts look simple enough, how do I get the front & rear valances off though? DO the bumpers need to come off first?

Cheers
Pad

[kam1987]

do u wana sell the kit

[zaust]

The front and rear are attached to the bumpers. so the front is a case of take the plastic squar's out each side of the number plate undo the 13's and the rest you will see.. the rear has to from underneath/ back of the bumper an a few smaller from inside the boot .. Should not take long at all..

[Pad]

Kam1987 - no thanks, you can buy the whole car off me once Ive restored it though...

Zaust - thanks bud, am getting it all up on stands this weekend to get cracking. I saw the bumper bolts, just didnt know if there were any on the wings holding it on...

Cheers
Pad

[zaust]

Ahh forgot there is... remove the 10's holding the plasict inner wing and you will find 1 each side...
and for the rear one just below the arial motor and one behind the + side of the batt....

[Pad]

nice one. Cheers Zaust.

just hoping there arent too many nasties underneath..