alloy wheel kerscher

[madmerv]

any opinions on this for a an is in sterling silver. Ԛ£476 at a place called dubmeister 7.5x16 et20. Would it fit and any opinions of the look of them ,I think there not bad but would like independant opinion as I'm also keen on borbet A's.

[nav786]

i like them, kerscher do have some very nice rims. these look like the borbet a's but IMO a little better

[panesar_e30]

nice rims, bit softer than the borbets. seen a set on an e21 at ace cafe

[madmerv]

will fit with et20 or need spacer?

[nav786]

no spacer needed with et20. but with 7.5" wide i think you wont have much of a dish. the pic is probably of a 9" wheel.

[bootyman]

Fat wheels mate. I looked at them when i was replacing my wheels on the Rieger after my monster break upgrade, but i needed 18x12's rear and 18x10's front and they didn't do them that big otherwise i'd have bought them. Like Nav says, similar to the Borbet but better and besides lots of cars have the Borbets, but not many have these. Ho and i also agree about the width. 9's will give you a nice lip. 7.5 and you wont hardly see anything cause you will be missing the 1.5" between the 2 sizes

[TW166Y]

nice rims and look very similar to borbet a's however like nav said above that wheel is for "illustration" purposes only and is a picture of a 9J rim. 7.5 you wouldnt have much of a dish at all, go for borbets dude, you can pick a set up off ebay for about 3-400 with tyres maybe even cheaper than that?

[madmerv]

good ponit about the dish i had wondered about that. Still growing on me but the borbets can be got cheaper, finances will ultimately decide.

[bootyman]

Depends if you dont mind your car looking like a million other's

If money is an issuse then i'd go for the Borbets too as they are really nice too

[nav786]

if funds are available i would go for these, not too much more. and go 9" on the rear.