possible to fit side pods with se skirt?

[liam012]

ok in my unlucky quest to get an mtec II full kit this is my plan
keep nice se front valance as its very close to tecII look anyway - get a low key (not dtm style) rear diffuser to go under the rear bumper instead of that awful one that is stock and i kind of like the se side skirts too so i want to keep them - i was wondering is it possible just to fit the tecII side pods and how do you reckon it would look?
ta
liam

[E30Mark]

yes you could fit them, but it would look awful, sorry.

Sit back and wait for the Mtech fairy to deliver you a tec II kit...

[liam012]

it would look awful with se skirt you mean? or would just look awful in general?!
i dont know how it would look that different bar the skirt as bumper levels are at same height on tecII than the se?

[liam012]

youre right
not about the fairy though...

[E30Mark]

The door pods would stick out from the bottom of the door by approx 25mm, the SE side skirts would look 'lost' in my opinion against them...

[liam012]

cheers mate that definately anwers my question i had not actually thought of the indent.... there is me thinking 2d again.
cheers