M20 Turbo Adapter

[isTURBO]

Hi Guys

Ive just been to the 666fabrication site and while scrolling through I found this: http://store.666fabrication.com/m20-turbo-adapt.html

According to 666 it attaches to the std manifold on an M20. Its compatible with all T3/T4 turbos.

Just wondering if anyones used these and what are your experiences?
Alternatively any opinions on this would be greatly appreciated.

Cheers

[koos]

It looks like quite a good way of getting around the manifold problem. Arent those two piece manifolds rare though? Could make one for a normal manifold.

[Colonel Sanders]

jon volk of 666 fab said the full maifold will fit on a rhd car nice an snug, not too sure about the adapter though as they are for two piece manifolds mate?

[blingsta]

I'll speak to my mate Rivaaj and find out if he's got any 2 piece manifolds for ya... !

[isTURBO]

Cheers Guys

Thanks Erel.

Spoke to a mate yesterday and his only concern was that it may be too close to the exhaust system hence surrounded by a lot of hot air.

Looks pretty neat though.