320is conversion
Moderator: martauto
Just got an idea nd wonderin if it would be worth doin, Puttin a 320is engine (if 1 could be found) in a 318is. Considering it would be 50 hp increase at standard and still the handling advantages of the 4pot it looks good on paper. I know I could just get an M3 but I was thinkin of this cos the engine still looks the same as the orginal 4 insurance
-
Demlotcrew
- E30 Zone Team Member

- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
There is quite a fair bit to change, but its not impossible.
Andrew
Andrew
-
jaistanley
- E30 Zone Addict

- Posts: 2517
- Joined: Tue Jan 18, 2005 11:00 pm
- Location: Coventry and Essex
The 2.0 s14 engine will go in easitly enough with the only real problem I can see being the exhaust manifold fouling the steering column. It's an expensive way to get more power with the M42 engine being a gerat unit anyway.
Set of M3 3.2 evo throttle bodies and mega squirt would make her a quick little 1.8. See tims thread.
Jai
Set of M3 3.2 evo throttle bodies and mega squirt would make her a quick little 1.8. See tims thread.
Jai

you're too kind, only actually i think if the pic you're referring to is the one of the engine with the black bits looking standard and no bonnet on, you're actually right - it hadn't really been run before, as i'd just completed the engine conversion!Dave_M3 wrote:Ya Tims looks sweet, engine bay is so clean it looks like it never even ran before
I certainly think that there's a lot of room for modification to the m42 lump, i'd expect my current lump (2.1, throttle bodies, restricionless intake etc) to make approaching 320is power, although it really needs different cams to make the most of the ITBs.




