my e30 325 i

Show off your pride and joy here

Moderator: martauto

Post Reply
User avatar
bazpro
E30 Zone Newbie
E30 Zone Newbie
Posts: 72
Joined: Mon Dec 13, 2010 11:00 pm
Location: sunderland

Sat May 14, 2011 4:35 pm

sold my last e30 in january as it needed to much work but still got a soft spot for them and another one came up local ish for not alot of money so snapped it up.
its got 155k but engine runs really sweet,pulls well too. new discs and pads alround (but they still feel a bit crap?) aparently new susension aswell but i have no idea if its just standard or not. rides ok though.
unlike my other one every switch,gauge ect works which is a bonus :D
it has a quickshift on it (takes a bit getting used to) induction kit and a full stainless exhaust which i think is based on the standard one as it isnt to loud.
interior is stripped out with 2 buckets and sparco harnesses and looks like a mtec steering wheel.
bodywork isnt the best has few bits of rust on it and few scrapes here and there but looks ok with a polish. has sideskirts on which am not to keen on and was told it has a mtec spoiler on the back.
as its a second car i plan on doing a trackday or two and maybe a bit drifting which is why i wasnt to bothered about the bodywork.
Image
Image
Image
Image
Image
Image
Alpina99
E30 Zone Camper
E30 Zone Camper
Posts: 1000
Joined: Sat Nov 17, 2007 11:00 pm
Location: Portsmouth

Sat May 14, 2011 5:08 pm

Polished up quite well though,
Looks a nice motor & if you're tracking / drifting it - it's already half prepared,
:D
Gone, but not forgotten !!
User avatar
bazpro
E30 Zone Newbie
E30 Zone Newbie
Posts: 72
Joined: Mon Dec 13, 2010 11:00 pm
Location: sunderland

Sat May 14, 2011 5:15 pm

yeah polished up canny. could do with a lsd and the brakes looking at before goes anywhere near a track though.
was tempted to put a mtec 2 kit on it but dont want to spend to much on bodywork. would rather make it go and stop better.
Post Reply