what are the +points exactly of this cilinder head mounted on a standard 87' M20 2liter
somebody has some info for me?
(sorry for very bad english
)camshaft 300°
Moderator: martauto
-
AC-SCHNITZER
- E30 Zone Newbie
- Posts: 87
- Joined: Sat May 20, 2006 11:00 pm
- Location: West flanders, Belgium
i can buy a complete cilinderhead for m20 engine, mounted with "sliced" valves, special valve springs, and a 300Ԛ°camshaft for 300€
what are the +points exactly of this cilinder head mounted on a standard 87' M20 2liter
somebody has some info for me?
(sorry for very bad english )
what are the +points exactly of this cilinder head mounted on a standard 87' M20 2liter
somebody has some info for me?
(sorry for very bad english
)-
Ant
- Retired Team Member
- Posts: 10496
- Joined: Tue Dec 21, 2004 11:00 pm
- Location: PD+E dept :D
300 degrees will idle very badly, advise throttle bodies (x6) for anything over 288 duration.
need to know the valve lift too, you may need to machine the pistons to clear the valves @ full lift
seems a bit OTT spec wise for a 320 though dude........
need to know the valve lift too, you may need to machine the pistons to clear the valves @ full lift
seems a bit OTT spec wise for a 320 though dude........
Product Development and Endurance for Delphi.
Original performance chips, original works not unlicensed copies
Email FTW
Original performance chips, original works not unlicensed copies
Email FTW-
maxfield
- Old Skooler
- Posts: 15185
- Joined: Sat Nov 26, 2005 11:00 pm
- Location: Mansfield
Im sure you're pistons need valve pockets with this cam.
-
AC-SCHNITZER
- E30 Zone Newbie
- Posts: 87
- Joined: Sat May 20, 2006 11:00 pm
- Location: West flanders, Belgium
the guy says the cilinderhead comes from a standard 325 underblock.maxfield wrote:Im sure you're pistons need valve pockets with this cam.
the underblock from a 320, 323 and 325i are the same? just the piston-cam (or how is it in english, the axle were the power of your pistons comes on)
are different from 323i
-
maxfield
- Old Skooler
- Posts: 15185
- Joined: Sat Nov 26, 2005 11:00 pm
- Location: Mansfield
The stroke and bores are bigger thus giving bigger displacement.
The head will fit but it's not that worth it TBH but if you were to fit it to anything it's worth fitting it to a 2.7 with custom pistons with valve pockets. And have one awesome machine.
The head will fit but it's not that worth it TBH but if you were to fit it to anything it's worth fitting it to a 2.7 with custom pistons with valve pockets. And have one awesome machine.