OBC removal-Wont start?

[eko]

Ive searched through 12 pages in the tech section for an answer but cant find it so....

After taking out the OBC on 325i it will no longer start!

Can someone tell me what it is i need to do?

[Bob_S]

you need to by pass the immobilser on the obc ;) I thought you would have known this laird!

[eko]

I know its the OBC immobileser but dont know any more than that!

Anyone?

[telski789]

have you just taken the obc itself out? if so you need to unplug the yellow plug that plugs into the back of the clocks,this is where the obc gets its power! should disable the immobiliser.......so im told.....

Tel

[Bob_S]

there will be a break in the ignition cable where you unplugged the ecu thingy. you will have to look up the ig. wire colour green/pink rings a bell but I am not at all sure.

[Brianmoooore]

!

Ive searched through 12 pages in the tech section for an answer but cant find it so....

After taking out the OBC on 325i it will no longer start!

Can someone tell me what it is i need to do?

I've posted this twice in the last week alone!!
Above the top of the glovebox there is a white two pin socket with two green wires going to it from the car loom. The OBC plugs into this.
Remove the OBC plug, and, if you are lucky, there will be a similar plug with a short loop of green wire fitted to it tied up to the loom nearby.
Plug this loop into the socket and the immobilizer will be bypassed.

[eko]

Brian your a star mate,like i said i did try a search but f**ked if i could find it!

Ill give it a go tomorrow,thanks again mate