Hi Everyone,
I’m a bit lost as to how to attach the lower wheel well cover (10 in the photo, part no 51711943830)
I can see two hex head screws potentially going in? Would that be no 3 from the diagram?
Thanks!
How to secure the wheel well housing cover?
Moderator: martauto
-
twenty
- E30 Zone Regular
- Posts: 598
- Joined: Wed Jun 24, 2020 11:43 pm
- Location: London
You do not have the required permissions to view the files attached to this post.
-
Tzantushka
- E30 Zone Regular
- Posts: 464
- Joined: Sat Nov 24, 2018 4:18 am
- Location: Melbourne, Australia
Have a look at this post in my build thread and you'll see it's attached by:
1x screw at the top (sandwiched underneath the wheel well liner)
1x screw at the bottom
1x screw at the top (sandwiched underneath the wheel well liner)
1x screw at the bottom
-
twenty
- E30 Zone Regular
- Posts: 598
- Joined: Wed Jun 24, 2020 11:43 pm
- Location: London
Awesome! Are there bolts there already that the screws bolt on to or did you have to do install that too?Tzantushka wrote: ↑Sat Apr 17, 2021 11:41 amHave a look at this post in my build thread and you'll see it's attached by:
1x screw at the top (sandwiched underneath the wheel well liner)
1x screw at the bottom