Does the inlet manifold have to come off? Reading it doesn't but when I look at it its doesn't seem feasible with removing it.
Cheers[/list]
Pulling injectors from m20 - emission test results
Moderator: martauto
-
dimebag_from_hell
- E30 Zone Camper
- Posts: 1494
- Joined: Sun Aug 27, 2006 11:00 pm
- Location: NORTHERN IRELAND
Last edited by dimebag_from_hell on Sun Jun 12, 2016 4:57 pm, edited 1 time in total.
"Service to others is the rent you pay for your room here on earth."
-
Cloggy Saint
- Old Skooler
- Posts: 8027
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: zummerzet
No need to remove the inlet but removing the rocker cover makes things a bit easier.
E30 zone - promoting adult illiteracy since 2004
-
dimebag_from_hell
- E30 Zone Camper
- Posts: 1494
- Joined: Sun Aug 27, 2006 11:00 pm
- Location: NORTHERN IRELAND
Cheers mate.
My carbon monoxide results at idle were 2.34% vol and the limit to pass was 3.5% vol.
HC were low at 128ppm with a limit of 1200ppm.
What do you fellas think about the CO levels? Blue temp sensor has been tested at ECU and I have a 300 mile round trip to do this day to Kilbroney car show and I'm hoping to get this sorted.
My carbon monoxide results at idle were 2.34% vol and the limit to pass was 3.5% vol.
HC were low at 128ppm with a limit of 1200ppm.
What do you fellas think about the CO levels? Blue temp sensor has been tested at ECU and I have a 300 mile round trip to do this day to Kilbroney car show and I'm hoping to get this sorted.
"Service to others is the rent you pay for your room here on earth."