where do these wires go?

[Finto_316]

Doing engine conversion from 320i to 325i. I've put battery in boot with genuine kit. But I can't seem to figure out where these two wires go . one is on starter loom, not sire if its for starter as there's already two wires on starter. Other wire comes out of bulkhead.theres two wires together with same ring connector on end.Not sure if an earth or for positive connection on terminal.

[Finto_316]

Won't let me upload photos!!

[Brianmoooore]

What are the colours of the wires? They may have a black outer sheath.

[Finto_316]

Small one ran to top of starter. But the two together are an earth but I don't know where abouts it earths to. Car runs with it earthed. Didn't check colour but the two wires are shaped to earth at same point.

[Brianmoooore]

If you want the wires positively identified, I need colours.

[Yeti]

i just wired up a 325 lump mate take a photo of the wires and where they are i should be able to help you

[Finto_316]

Brian. The wires are wrapped in black factory core. In one of wires there are brown and orange and brown and yellow. In the other wire is just all brown and about 4 or 5 wires.

[Finto_316]

If you want the wires positively identified, I need colours.

. Any ideas Brian?

[Brianmoooore]

What are the ages of both the car and the engine that's gone into it?