Hi fellas
Im looking to replace my slave cylinder on the weekend of my 325i and was wondering if any one knew what size spanner i will need to whip off the hydrolic hose attatched to it and is is the same size both ends?
Ive got loads of spanners but want to get a flared headed one to try to avoid cheesing it if its a tight fit.
Thanks in advance for if i get any replies.
What size spanner please?
Moderator: martauto
-
HairyScreech
- Engaged to the E30 Zone
- Posts: 6265
- Joined: Sun Jan 21, 2007 11:00 pm
Think it is 11mm but your milage may vary.
all depends on the hose fitted, could be a 10, 11, 12 or 13mm.
all depends on the hose fitted, could be a 10, 11, 12 or 13mm.
2.8 development thread http://www.e30zone.net/modules.php?name ... c&t=170822
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
m3.3.1 m20 thread - now running, chip needed - any volunteers?
http://www.e30zone.net/modules.php?name ... =viewtopic&
