Ignition Problems Still HELP !

[m-dtech]

Ok so far;

Replaced. Rotor Arm, Dizzy Cap, HT Leads.

I have traced the -ve feed and all seems ok.

What voltage/current should i be getting at the +ve of the coil ?

Is there anything to do with the engine relays that could affect the +ve feed ?

Batter is fully charged.

HELP !

[fixedwheelnut]

Should get between 10-12 volts at the coil depending on the type of coil it should be marked on it.
Check the DME relay that powers the ECU it will be the 5 pin white one.