alloy heater pipes

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
xavier
E30 Zone Regular
E30 Zone Regular
Posts: 743
Joined: Thu May 29, 2008 11:00 pm
Location: Western Australia

Post Thu Jul 12, 2012 8:30 am

I have taken my heater valve out. The two pipes that run through the bulkhead have a few small holes in them. I was going to fill them with solder and sand them back? anyone tried this? Is there some stuff HB weld(?) that people use instead of solder?
Top

Return to “E30 Technical Help”