Refurbing Tatty Bumper Trim

[318isPMK]

I have degreaser, Primer, holts satin black paint and sand paper.....

Do I just go for it and sand it all in one direction and paint in the other or can I just give it a good going over prime it and paint it?

Never done anything like this so could use instruction

Thanks

[Tan91]

If you just rub it down with the correct paper it should cut the paint and scuffs back pretty well, then just start painting. Few good coats will do nicely.

Step 1: Rub down till its nice and smooth using a finer paper each time
Step 2: Degrease
Step 3: Find a nice clean surface which is dust free and paint!

Should do the trick mate.

Tan.

[318isPMK]

Cheers thought as much

[Tan91]

Before and After pictures? would be nice fella