Exhaust manifold downpipe flange nuts

Need technical Q/A then you're in the right place

Moderator: martauto

Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Sun Dec 04, 2011 12:51 pm

I'm trying to get the exhaust off the car, and I'm having troubles. Being LHD, I've got the twin-piece manifold:

Image

and I've having a nightmare trying to undo the nuts holding on the downpipe. I've managed to undo the manifold from the head itself, but the downpipe is locked on solid. I can't seem to get a socket over the nuts either because of the weld around the pipes.

I've also got a catalyser, so the downpipes go alllll the way back. Is there any way of undoing just the back section, and pulling the downpipes and cat up through the engine bay? Cos I've skinned all my knuckles trying to get these f**king manifolds off the downpipes, and it's pissing me off.
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sun Dec 04, 2011 3:13 pm

Someone has probably fitted 'ordinary' nuts, instead of the reduced size copper clad ones that should be there.
No idea if there's enough room to pull the whole lot up through and out of the bonnet, but you stand a better chance than on a RH drive car. You may be able to get it up far enough to grind or cut the nuts off.
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Post Sun Dec 04, 2011 4:51 pm

I managed to clout a 1/2inch socket (13mm) over one of them and got it off, so I think I'll just have to use the usual mixture of heat, oil and brute force. I just need to get a load of extension bars.

But these nuts are definitely not copper-clad, which is why they're giving me such a ball (and head, shoulder and arm) ache.