.......Smells
Moderator: martauto
-
SwirlyE30
- E30 Zone Squatter

- Posts: 1509
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Worthing-Brighton South Coast
Just let my mate have a go in my motor, and he tried spinning the wheels up a couple of times. Now it fcking stinks, kinda like burning wire, or burning somthing. And it dosnt pull as well.
Clutch?.....GAY!
Clutch?.....GAY!
1986 Chevrolet Corvette. 330ftlb torque....V8s rule!
-
Dan318-is
- Married to the E30 Zone

- Posts: 8006
- Joined: Wed Jul 06, 2005 11:00 pm
- Location: Surrey/London
my clutch is going too
theres a lesson to all this though
theres a lesson to all this though
-
ouch
- E30 Zone Newbie

- Posts: 211
- Joined: Wed Sep 14, 2005 11:00 pm
yeh dont let your mates fook with your car

-
SwirlyE30
- E30 Zone Squatter

- Posts: 1509
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Worthing-Brighton South Coast
Just got my mechanic dad to check, and yep its the clutch. Smells like it fo'show.
Fcking mates, was a shit wheelspin at that! if your gonna do it.......at least do it propperly!
Fcking mates, was a shit wheelspin at that! if your gonna do it.......at least do it propperly!
1986 Chevrolet Corvette. 330ftlb torque....V8s rule!
-
Demlotcrew
- E30 Zone Team Member

- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
-
Gwynleym10
- E30 Zone Addict

- Posts: 3650
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: London/Cymru
yea doing it properly probably does less damage to the clutch anyway! (but more to your tyres
)
Did you not look at the clutch when you did the engine swap?
Did you not look at the clutch when you did the engine swap?
-
elliot
- E30 Zone Regular

- Posts: 622
- Joined: Sun May 01, 2005 11:00 pm
- Location: banbury oxon
in 6 years im the only person to drive my car, except for the mechanic of course. get yaself an auto mate, no chance of any fun in em so no-ones interested in driving it 

-
SwirlyE30
- E30 Zone Squatter

- Posts: 1509
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Worthing-Brighton South Coast
Gwynleym10- No mate, didnt have time to look, or money to replace it lol.
Its still ok atm , but you can tell its on the way out. Very little bite left in lower gears, right on the edge. And it dosnt pull as well.
I always let people drive my car, everytime i do somthing it seems fine, but when my freinds drive it, somthing bad happens.
Thats it, no more!
Got to tax the piece of sh*t this week as well, service it, clutch, two more new tyres already. FFS.
Only bought it for 800 sobs lol, basically spent that whole car again
Its still ok atm , but you can tell its on the way out. Very little bite left in lower gears, right on the edge. And it dosnt pull as well.
I always let people drive my car, everytime i do somthing it seems fine, but when my freinds drive it, somthing bad happens.
Thats it, no more!
Got to tax the piece of sh*t this week as well, service it, clutch, two more new tyres already. FFS.
Only bought it for 800 sobs lol, basically spent that whole car again
1986 Chevrolet Corvette. 330ftlb torque....V8s rule!
-
johnono
- E30 Zone Addict

- Posts: 4677
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: land of the vikings
and u will again and again ... and ( u get the point)
but,.. when u say clutch gone, is it slipping all the time or only when u are gunning it some?
i went for a "spirited" drive with a fellow tourer last week, kept pace but at one point i threw fithand the clutch began slipping all the way up to 4500 so i eased off .
No probs with the clutch afterwards at all, but it got mega hot it began to loose its effectiveness
but,.. when u say clutch gone, is it slipping all the time or only when u are gunning it some?
i went for a "spirited" drive with a fellow tourer last week, kept pace but at one point i threw fithand the clutch began slipping all the way up to 4500 so i eased off .
No probs with the clutch afterwards at all, but it got mega hot it began to loose its effectiveness
-
Motorhole
- E30 Zone Addict

- Posts: 2395
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: Cheshire
yep, I don't do wheelspins, doughnuts, burnouts or 1/4 mile runs, and there is no need for fast starts at track days because we run from the pit lane! No excuse for not looking after the clutch.
Incidentally, what is the labour on a clutch change/gearbox changed on an E30?
Incidentally, what is the labour on a clutch change/gearbox changed on an E30?
-
Jimbob
- E30 Zone Addict

- Posts: 3731
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Poole
Excessive wheelspinning!
M42 is still hanging on tight then?
M42 is still hanging on tight then?
-
Wilson325i
- E30 Zone Camper

- Posts: 1184
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Here in SE
yes there is a lesson indeed, wheelspinin,doughnouts??(sp)burnouts,drifting, E.T.C, all this318-is wrote:theres a lesson to all this though
-
SwirlyE30
- E30 Zone Squatter

- Posts: 1509
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Worthing-Brighton South Coast
lol, she runs sweat normally boys. I got the car for 800quid.....so i aint too bothered.
The clutch seems to be alright now, or at least better anyway. So im thinking what Johnono is saying is prolly right, it must have heated up a bit, but now it seems better. Is still a little on the edge, but ill change it soon anyway, might do a bit of a rebuild on the lump soon anyway as the cars mint
The clutch seems to be alright now, or at least better anyway. So im thinking what Johnono is saying is prolly right, it must have heated up a bit, but now it seems better. Is still a little on the edge, but ill change it soon anyway, might do a bit of a rebuild on the lump soon anyway as the cars mint
1986 Chevrolet Corvette. 330ftlb torque....V8s rule!
-
Jhonno
- Homo Hair
- Posts: 20362
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: FLAT, FLAT, FLAT!!
if it was the clutch it would slip in higher gears when you put your foot down..
a clutch slip is v v obvious
a clutch slip is v v obvious



