Can anybody help wit remove of this part as I'm strangling to undo the nuts tried everything even pulled the grommet out thought will be able to get the nut from the front of the car but no luck was wandering may b the is Easyier way of getting this part off as you can see is leaking wit antifreeze any help will b most apriciated thanks!!
Helmi
Heater matrix can u help
Moderator: martauto
-
helmi25cab
- E30 Zone Newbie
- Posts: 108
- Joined: Tue Dec 16, 2008 11:00 pm
Last edited by helmi25cab on Tue Dec 17, 2013 9:27 pm, edited 1 time in total.
-
Grrrmachine
- E30 Zone Wiki / Team Member
- Posts: 8043
- Joined: Sat Feb 09, 2008 11:00 pm
- Location: Warsaw, Poland
Taking the glovebox out makes that job a lot easier.
'89 325i Touring | Touring Resto Thread | In-Dash Screen install
-
helmi25cab
- E30 Zone Newbie
- Posts: 108
- Joined: Tue Dec 16, 2008 11:00 pm
Fuck!!! nowI have snap the pipe help need a new 1
Iirc I've gone through the engine side with an extension. Make sure you change the o rings, there are four to do both pipes. people will recommend using the gen BMW ones, although they have replaced the part with normal radiused o ring compared to the original flat type, so any quality o ring will do the same job imo.
1982 E21 316 Baltic Blau
1989 318i 2 Door Sterling Silber
Feedback: http://www.e30zone.net/modules.php?name ... highlight=
1989 318i 2 Door Sterling Silber
Feedback: http://www.e30zone.net/modules.php?name ... highlight=
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49358
- Joined: Mon Jan 10, 2005 11:00 pm
Those nuts can be undone with an appropriate size ratchet ring spanner, or by a short extension from a 1/4" socket set.
-
helmi25cab
- E30 Zone Newbie
- Posts: 108
- Joined: Tue Dec 16, 2008 11:00 pm
Too late now because I have snap the pipe is anyone breaking one cash waiting many thanks for your help much apriciated need one ASAP