Diff removal

Need technical Q/A then you're in the right place

Moderator: martauto

Post Reply
User avatar
Andy-M
E30 Zone Newbie
E30 Zone Newbie
Posts: 123
Joined: Sat Nov 14, 2009 11:00 pm

Sat May 18, 2013 5:22 pm

Any top tips on getting the top two retaining bolts undone. There no room to get my big bar between the top of the bolt and the floor. Even swearing at it didn`t work........ :roll:
Grrrmachine
E30 Zone Wiki / Team Member
E30 Zone Wiki / Team Member
Posts: 8043
Joined: Sat Feb 09, 2008 11:00 pm
Location: Warsaw, Poland

Sat May 18, 2013 5:29 pm

Ring spanner, then a second one locked on to it as an extension.
jimbom30cab
Tech 1 freak
Posts: 7634
Joined: Mon Oct 12, 2009 11:00 pm
Location: in the garage

Sat May 18, 2013 5:31 pm

with lots of WD40
maxfield
Old Skooler
Old Skooler
Posts: 15186
Joined: Sat Nov 26, 2005 11:00 pm
Location: Mansfield

Sat May 18, 2013 5:37 pm

Grrrmachine wrote:Ring spanner, then a second one locked on to it as an extension.
That!

They will be tight and there's a good chance your going to skin your knuckles.
Image
User avatar
Andy-M
E30 Zone Newbie
E30 Zone Newbie
Posts: 123
Joined: Sat Nov 14, 2009 11:00 pm

Sat May 18, 2013 8:43 pm

Panic over....... Lol.
Found a mug of PG and a couple of chocolate Hobnob`s did the trick...... winkeye
Heavy bugger when it slid off the jack and landed on my arm. :mad:
How can something so small be the weight as a small planet...
User avatar
Shmallpaul
E30 Zone Newbie
E30 Zone Newbie
Posts: 120
Joined: Fri Sep 28, 2012 11:00 pm

Sat May 18, 2013 11:39 pm

The real fun is getting it back on again! :D
Rav335uk
E30 Zone Meets/Events Team
E30 Zone Meets/Events Team
Posts: 27985
Joined: Wed Jan 19, 2005 11:00 pm
Location: Mad mad mad
Contact:

Sat May 18, 2013 11:45 pm

I hope you put alittle bit of Loctite on the 4 bolts.
If you can't torque them up, it helps, as they have been know to work loose. 8O
Image
If you Got "Haters",Then your doing something Right!
CR24v??? Where's it all gone?? LOL
User avatar
Shmallpaul
E30 Zone Newbie
E30 Zone Newbie
Posts: 120
Joined: Fri Sep 28, 2012 11:00 pm

Sun May 19, 2013 9:33 am

I can vouch for this.. as I found the source of my clunking sound when shifting was due to one of these suckers completely coming out, and the other about 3/4 there :mad:
Post Reply