Decent tuning place for MAF conversion

[rowemeister]

Hi

I know Bexley is good but its a million miles away from me in sunny Doncaster.

All I want to know is where everyone has had their MAF conversions done and do you recomend them.

Ta!

[e30_Turbo]

Hi

I know Bexley is good but its a million miles away from me in sunny Doncaster.

All I want to know is where everyone has had their MAF conversions done and do you recomend them.

Ta!

All you need is the MAF and a unichip, so find a unichip dealer your way, must be one, I should know as I lived there for about 2 years and my parents still do.

You can get the MAF from Quarry motors or equivalant breakers, I think you need some flexible hosing to connect it all up, but the main part is getting it mapped properly, Unichips can do this, I've seen a few myself.

Try dastek.co.uk for info on where and there is a zoner who maybe able to help you out getting one too. Send us a Pm if you want the details.

HTH, Mark.

(my apologies if you knew all that )

[rowemeister]

Cheers Fozzy,

Sal aka M5pilot helping out alot, just dont want to travel too far.

I suppose the journey back would be good though

There is a great BMW breaker near me, he gets all the insurance jobbies.

[Hap]

guy in barnetby , nr scunny dennis vessey has rollers

[e30_Turbo]

Cheers Fozzy,

Sal aka M5pilot helping out alot, just dont want to travel too far.

I suppose the journey back would be good though

There is a great BMW breaker near me, he gets all the insurance jobbies.

I think you need a e36 323i MAF, but I'm not sure tbh, you could always ask Belxleys what the recommend.

Or......get a MS like me and dump the AFM totally and run a map sensor and lambda, it's not as expensive as you may think

Being able to map yourself, change the settings, add other sensors etc is the way forward, but not for everyone, but there is two of us that can help out if needed No need for RR's, you can tune it on a laptop!

Or there is emerald, but thats about Ԛ£1k after mapping etc.

[e30_Turbo]

guy in barnetby , nr scunny dennis vessey has rollers

Sunny scunny, been there a few times, there is a really steep hill just after the aqauduct if I remember right, I nearly died on that hill when I was loaned a mates bike and it did not have any brakes!!!

[tbmw]

Cheers Fozzy,

Sal aka M5pilot helping out alot, just dont want to travel too far.

I suppose the journey back would be good though

There is a great BMW breaker near me, he gets all the insurance jobbies.

I think you need a e36 323i MAF, but I'm not sure tbh, you could always ask Belxleys what the recommend.

Or......get a MS like me and dump the AFM totally and run a map sensor and lambda, it's not as expensive as you may think

Being able to map yourself, change the settings, add other sensors etc is the way forward, but not for everyone, but there is two of us that can help out if needed No need for RR's, you can tune it on a laptop!

Or there is emerald, but thats about Ԛ£1k after mapping etc.

hope you dont mind me butting in, but whats needed to change to ms and how much is it?