Anyone from Scotland interested in bits from a mint 318is ?

[Hibsfan1875]

1) Topblag - electric aerial, front seatbelts mechanisms, ,front wings, rear opening windows. doors, bonnet seal, sunroof panel , under-dash panel, wipers/motors/scuttle vents, bumper mounts front and rear, rear number plate holder, battery securing pin, exhaust heat shields, mudlflaps, bonnet release handle, side indicators, hazard and rear screen heater switches

2) Sanchez(Peter Duck) - Bumpers, Lip Spoiler and Headlights, wheels(minus caps!!!!!) valance, Map light mirror, leccy window switches. ECU possible lock set if full

3) e21 Jason - LSD, Carpet, fuel tank,fuel lines, filler neck, Glovebox, Stereo Facia

4) HibsFans1875- engine and gearbox, Parcel Shelf, passenger Gutter Trim, heating matrix, blower motor and accel cable, gear knob, clutch, Rear light wiring looms, airbox hoses. peter knows which one.

5) Tedswagon - interior, speedo, steering wheel, center cap badges, central locking relay & solenoids, wing mirrors, boot & spoiler, suspension and bits! Door seals, both from door and car. Mine loose one is bugging me.

6)Ricey46- front and rear screen

7) EVIR - DASH

8 Neil320Touring - Bonnet

9) Muraska - Battery

* more bits and bobs on my list *

[Topblag]

where is the place about? I will be there or wherever as early as possible, just hope it's not pissing down.

Where are you coming from ?

Falkirk.

If you're coming from the Kincardine Bridge, head for Inverkeithing, when you get through Rosyth, go straight through the roundabout with the motorway above it and take a left about 50-100 yards before the next roundabout, down the hill and you're there. I'll give you a call before Saturday to finalise arrangements.

[Topblag]

Does anyone have any time this week to get in to do some work to make sure the engine comes out clean ? I'm working all week, no opportunities.

[muraska]

has anybody claimed the centre console if not can you add it to my list

[Hibsfan1875]

does the car have rear speaker pods? if so can i get them?

[Sanchez]

does the car have rear speaker pods? if so can i get them?

only tourings come with rear speaker pods.

PS the rubber hoses will be attached to the engine.

Muraska, front or rear center consule?

[Sanchez]

1) Topblag - electric aerial, front seatbelts mechanisms, ,front wings, rear opening windows. doors, bonnet seal, sunroof panel , under-dash panel, wipers/motors/scuttle vents, bumper mounts front and rear, rear number plate holder, battery securing pin, exhaust heat shields, mudlflaps, bonnet release handle, side indicators, hazard and rear screen heater switches

2) Sanchez(Peter Duck) - Bumpers, Lip Spoiler and Headlights, wheels(minus caps!!!!!) valance, Map light mirror, leccy window switches. ECU possible lock set if full, mats if Jason dont want them. Interior light delay if fitted. fuse box lid. Front seat belts.

3) e21 Jason - LSD, Carpet, fuel tank,fuel lines, filler neck, Glovebox, Stereo Facia

4) HibsFans1875- engine and gearbox, Parcel Shelf, passenger Gutter Trim, heating matrix, blower motor and accel cable, gear knob, clutch, Rear light wiring looms, airbox hoses. peter knows which one.

5) Tedswagon - interior, speedo, steering wheel, center cap badges, central locking relay & solenoids, wing mirrors, boot & spoiler, suspension and bits! Door seals, both from door and car. Mine loose one is bugging me.

6)Ricey46- front and rear screen

7) EVIR - DASH

8 Neil320Touring - Bonnet

9) Muraska - Battery, center consule

[muraska]

sorry the one that surrounds the handbrake

[Sanchez]

sorry the one that surrounds the handbrake

Yours!!!

PS where you gona buy the 318i tourer down south?

[muraska]

i was interested but it was on bricks
but i might have something else lined up

[Sanchez]

ive prov bought it.

just need a trailer.

[muraska]

hope you got it for a good price
just get a set of wheels and a mate drive down and pick it up

[Sanchez]

its untax, wheels are in my garage. Yes not much cash comeing out my bank.

[muraska]

good luck hope you sort out a trailor for it

[Topblag]

UPDATE- spoke to U-Pull-it today and set my expectation that nothing will be broken off the engine for removal, it'll be properly removed. They confirmed that is their approach. I'm not convinced but it should give us a bargaining chip if they break anything.

Also, the area we're working in has a concrete base so we won't need boards for under stands/jacks.

Paul (Ricey46) is coming from 9-11am to lend a hand, then Jason will take over when he arrives.

I'll be travelling with Ronan so we'll meet Paul and Pete (EVIR) in the car park at U-pull-it at 8.45am.

[gcs325i]

Good luck with their engine removal techniques, think they used a fork lift and a stihl saw on Jakes purchase. A few things to lie down on would be helpful, like carpet or cardboard, because even with it being a concrete base, there still pools of water/oil.

[EVIR]

If you're coming from the Kincardine Bridge, head for Inverkeithing, when you get through Rosyth, go straight through the roundabout with the motorway above it and take a left about 50-100 yards before the next roundabout, down the hill and you're there. I'll give you a call before Saturday to finalise arrangements.

I think I know the place, picked a parcel up near there before. Shall try to be there before 9.

Pete

[Topblag]

If you're coming from the Kincardine Bridge, head for Inverkeithing, when you get through Rosyth, go straight through the roundabout with the motorway above it and take a left about 50-100 yards before the next roundabout, down the hill and you're there. I'll give you a call before Saturday to finalise arrangements.

I think I know the place, picked a parcel up near there before. Shall try to be there before 9.

Pete

That's the one, there was/is a DHL or similar depot nearby. I'll PM you my mobile number, call me if you get stuck.

[Sanchez]

I can get the van from 8am onwards so if I get up earlier ill be there earlier!!!!

[Hibsfan1875]

guys see the gutter trim can you get the clip that connects them together, can you get me that too please. cheeers

[Sanchez]

guys see the gutter trim can you get the clip that connects them together, can you get me that too please. cheeers

You dont ask for much Alec do you. I think im gona need to write a list just for you!!!

Yes no probs, ill fit it all(not engine) when you round the week after.

Are you off work the 13th feb? We havin a meet.

http://www.e30zone.net/modules.php?name ... highlight=

[Topblag]

Fellow fraggers..... Final arrangements:

I'm picking up the mobile engine crane tonight and don't expect any problems.

Ronan and I will travel together on Saturday, Peter will bring the van and Paul, Pete (EVIR) and Jason will make their own way. They won't let us in until 9am so we can gather in the car park beforehand (for those who can make it).

Between Ronan and I we've got two trolley jacks and four axle stands so that'll be enough. Please try and bring a box each for your smaller items. Peter has the bags for bolts/screws/clips covered also.

I think everyone has my phone number so give me a call if you have any probs.

Cash on the day please.

See you Saturday !

[Sanchez]

Cool, Ive got straps for keeping stuff in the van safe as well, but if people have some please bring them.

I will be driving back safely but if it aint tied down well its gona roll, and I wont take full responsibility if something is broken unless it is down to my driving or carelessness.

I presume Paul will take the glass away with him anyway.

[johnt0709]

I would like to see some before and after pictures

[Tedswagon]

I'm just uploading the before photos to photobucket now. Must remember to take the camera on Saturday!

[Tedswagon]

Here are the before.

[Topblag]

Cool, Ive got straps for keeping stuff in the van safe as well, but if people have some please bring them.

I will be driving back safely but if it aint tied down well its gona roll, and I wont take full responsibility if something is broken unless it is down to my driving or carelessness.

I presume Paul will take the glass away with him anyway.

Fair point Peter, no probs.

I assumed we'd have to put the glass in the van - but let's see what Paul thinks. There's also the bonnet for Neil - have you got room in the lockup for it ?

[Sanchez]

Yep that'll fit in my garage. Ill ask Neil what he wants done with it. Ive fitted a bonnet in the back of my tourer but the bonnet was bent so dont no if a straight on fits.

[grantfk10]

I'm watching this thread with interest, good luck guys - hope it all goes well!

Any chance I can blag the "318iS" badge off the boot, or has someone claimed that too, lol!

[Sanchez]

I'm watching this thread with interest, good luck guys - hope it all goes well!

Any chance I can blag the "318iS" badge off the boot, or has someone claimed that too, lol!

I think its spoken for Grant but ill whip it off for you if noone wants it.

[grantfk10]

No probs Peter, let me know if its going spare, or if someone has claimed it first.... just looking to put a badge back on the touring before it goes up for sale at the end of March.

[Topblag]

Think I've got a badge or two in the lockup if any one will do - I'll check at the weekend.

[Sanchez]

Ive got a 318i badge you can have.

Why you selling? Cause the cabbys coming out the garage!!!

[muraska]

good luck for tomorrow guys

[Topblag]

cheers pal, much appreciated.