E30 Zone

Good meeting you mate, hope the LPG kit gets installed and you make good use of it...

I have a kit available here if interested;

http://www.e30zone.net/modules.php?name ... 13#2048713

Sold Colin a strut bar and steering wheel, great communication. thanks

Yep, top marks again, trustworthy chap!

Sorry, I bet this has been covered so many times before but I can't seem to find much in the search.

Do 1990 rear lights off a e30 fit the cabs as well?

top bloke, no fuss, easy to deal with.

Thanks

Maj

car is driveable on lpg now!! I've been using the link Gareth provided. Brian; i think the 02 sensor setting is right (0-1v) i need to adjust the stepper a bit as it does get a bit jerky, especially on cold. temp is below half when driving feels down on power at the moment should the car be a bit ro...

Earth is fine, i used another earth and it didn't make a diffrrence. I have got tried to tune the vaporised to help the car idle better, used a manual stepper and got the idle right. However once putting on the Leonardo stepper, the car is not as smooth, I have hooked up a laptop, just need to get t...

Car is partially running on lpg now, think i'll have to look into what Gareth has said above about clogged up solenoids.

car runs in 1st/2nd gear but quite hesitant, loses power in 3rd altogether.

the tank is making a ticking sound, not loud but not sure why this is?

Anybody heard about this?

sorry if it is a repost, can't see a similar post in here!!

http://www.yell.com/motoring/blog/wave- ... ansplants/

Will try get some over the weekend, Photobucket etc are blocked at work!!

What is tech 2 front bumper and valance worth now days

decent condition

I have one that i'm thinking of getting rid of.

what is a replica rear tech 2 bumper worth, never been on a car, nearly new, not fiberglass (plastic), one piece bumper

Have you tried switching over as I described above? It can take a couple of seconds, you need to be moving in gear to keep the engine turning over whilst the changeover happens, revving at a standstill is unlikely to work unless the car is well setup, which is unlikely striaght out of the box. Alex...

I will move the mixer so it will be closer to the afm tonight

Would the mixer being placed further away from the afm stop the car running on gas?

Start car on petrol, when i switch over to lpg (turn switch to lpg), amber light constantly flashes on the lpg switch, car is still driveable however when i rev over 2000 rpm i can hear the lpg ecu tick over and then the car will lose power. It goes into the ignition position where all the lights ar...

Update: Got vaporiser sorted, connected pipes and the rest of the wiring. Filled up the tank once i figured out how to fill it up!!) 2 problems: I can smell gas inside the car, seems like it is coming from the heaters? not sure but i will check this properly When i switch over to gas there is an amb...

Thanks for your help guys...

All done BUT when it came to bleeding the radiator i discovered a water leak!!

Vaporiser is leaking from one of the water pipes, need to source a rubber seal now

Leonardo yellow x2 ”“ red/white injector wires ”“ do I connect both yellow wires to the red/white wires? Split red/white attach yellow/yellow each end, picture in the link above of where I did it. When i split the red/white wire; do i still need to rejoin it? So when i connect the leonardo yellow w...

Are there any other reason why the battery light is on?

I'll try to find the fault tomorrow..

I have just got my car back on the road (91 e30 325i) and the battery light is always on apart from when the car is actually started. i have put in a new battery when the car is on it charges the battery but when left off overnight it kills the battery i have yet to check the alternator charge with ...

Brian,

to make this clear..

vaporiser-in connects to the bottom pipe in the car

Vaporiser-out connects to the top pipe in the car

so 2 pipes in the car get cut and tee peices inserted into both..

Anyone?

Car is off road at the mo!1 Thanks for the tip anyway :) Leonardo blue ”“ alternative fuel electrovalves x 3 ”“ where are these exactly? These are the propane/lpg valves, one on the tank, one in the engine bay and one on the vapourisor. [/b] Right... Need to connect the valves; one wire from the val...

Thanks!!

Gona have a crack at this today!!

I need help putting the Leonardo ecu wiring in my car, I have searched the forum and found it very useful but need some help/tips on where to get the wiring from. I’ve already got the documents showing the wires etc from the zone Leonardo brown ”“ negative coil or black wire from pin 9 C101 ”“ where...

Thanks,

This is exactly what I needed!!

Installed most of the kit yesterday, just need to figure out whether the switch is a clutch or brake switch..

I put that white switch on myself initially it had another connector which just sent a wire back into it.

Green plug i believe that plugs in behind the speedo.

62111372218

I'm looking to install my cruise control kit tomorrow, i can't figure out some of the wires, can anyone help?

Spray paint

Diamantschwarz metallic (181)

what size cans do you sell?

Which companies are best for LPG insurance?

I can get a decent quote without the LPG conversion but when i add it goes up quite a bit..

Not found anything using the search function..

Don't have a LPG certificate

I need to get my HID front lights aligned as i had them off the car.

How high should the beam of the lights be?

I have not found much via the 'zone search'

I was thinking of parking the car facing a flat wall and getting them to match but should the lights be set to a certain level from the ground?

I'm about to put my driveshaft back on my 325i When replacing the centre bearing do i need to replace the dust guard as i didn't get one with my new centre bearing. Also, how do i put the drive shaft back on with the gearbox and diff in already on the car, looks to be quite difficult. When i removed...

Suspension pad (10mm) X1 33531136387
Exhaust ring X2 18111723541

Thanks guys,

Will do this and not over tighten it this time!!

I was putting new fluid into my 3.64 lsd and when i went to tighten the lower bleed bolt i cracked the part underneath it.

Can this be repaired?

Can it be welded?

i have a spare standard diff and it seems to be the same size.

Will this fit?

any suggestions?

Search found 278 matches

Re:

Re: How much to convert an E30 to LPG?

Re:

Re: ezagood very good buyer

Rear lights

Re:

Re: LPG wiring

Re: LPG wiring

Re: LPG wiring

Wave goodbye to engine transplants

Re: Tech 2 front bumper

Tech 2 front bumper

Re: LPG wiring

Re: LPG wiring

Re: LPG wiring

Re: LPG wiring

Re: LPG wiring

Re: LPG wiring

Re: Battery light

Battery light

Re: LPG wiring

Re: LPG wiring

Re: LPG wiring

Re: LPG wiring

LPG wiring

Re:

Cruise control part

Cruise control question

Spray paint

LPG insurance

Aligning front lights for MOT

Putting driveshaft back on

Price please

Re: LSD hairline crack

LSD hairline crack