E30 Zone

I have had a similar problem at high speed the whole dash board would shake. Got the balancing done on all 4 wheels which help a bit On inspection of the prop-shaft coupling it was slightly worn away , when i had remove it there were cracks on the sides Its now replaced with a new item and its much ...

I would recommend a mild chip you will get 3 to 7 BHP,this may not sound much however you will fell the difference when driving.

It also improves your mpg if you drive sensibly and the plus side its not going to cost a bomb there are coulpe of Zoners who sells them.

Take the advise from Banjo I had to change both of my rear bearings,i took it to my mates garage and what was suppose to be a couple hour job took them about 4 to do one side, and one of the bearing got wreck when they tried to fit it in, which meant odering a new one. Dont think of the cost just pa...

Good Choice i am using the mild chip from Speedtouch and am happy with it ,the down side you will find you want to put your foot down alot more.

My G reg 325 done 155k and still running sweet

I got one of these mild chip as well, and I was in a panic for a while when I install it. When I was running it in, every time I stop the car would stall so felt like a learner. After an hour of driving around it settle down and everything ran sweet. As for being economical well have seen it yet as ...

Thanks to Spadge my car is running sweet,gave him a call for set of ignition leads got them within two day and at a good price.Highly Recommended.

Thanks Jules

Hi Guys i am in the heston,we should try and have a meet up while we have all this lovly sunshine.

Check your alarm system my brother had the same problem with his 316 which has a clifford alarm. he still hasn't resolve it. After his battery died I gave him a Bosch Silver battery which i use to have on 320 and his car killed it with in a few months. My 320 had no alarm and i can let it it for mon...

I had use these bulbs from Maplin http://www.maplin.co.uk/module.aspx?ModuleNo=25544&doy=22m7 you will have to use two 6 volts (the orginals ore 5 volts). then just solder them in. Total cost £1.98 Also are you aware the light switch is a dimmer switch as well.which dims thde OBC and the instrument ...

Remove the brackets of the glove box and see if you can see any rust on the bulk head. As Kabeer mentioned block elephant trunk leads to this problem I had nice rust hole which I patch up with aluminum mesh and heavy duty sealant which get rock hard. This fix has lasted 8 years now On the 325 I had ...

I will keep checking,but from you are saying I might be safer to get the same center until I can be sure.

So if the back box is 3 piece then I can set up the whole system as a three piece.

I try to check the cat back on the evolve site but can't find it, or it could be blocked as I am at work and they have blocked all the pictures on the zone.

Can you let me know what the link is.

Thanks

one more

cool car

It looks like I have pic 1 & 2 from your sketches Here are some pic of mine Rear box http://img150.imageshack.us/img150/8985/ex4ej9.jpg Center box connection not the cracked pipe :( http://img150.imageshack.us/img150/6364/ex1hc2.jpg Front of the center box http://img150.imageshack.us/img150/2108/ex2...

this is my route which i am working on

Use a mild chip which will help with the power and improve mpg in town.

Change the exhaust manifold which will give a bit more power

Use a lower diff I am aiming for 3.45 as i use the motorway this will result higher speed at lower revs.

am i right in thinking scorpion rear boxes are 3 piece anyway? with an adapter to fit them to the front piece from a 2 piece system?

Thats a relieve Gibson

So there is hope afterall as GFS has the center at a decent price I can then set it up as a 3 pcs

and get the manifold at a later date.

Hi I have a 325 with a 2 pc exhaust, the rear box is a Scorpion which came with the car. as my center box is now blowing, can I get the the front bits from a 3 pc system and use it with my Scorpion box. I am looking to get the hottuning manifold in the future which only seems to work on the 3 pc sys...

I had order my mild chip Thursday evening and got it on Saturday, It also came with instructions as how to fit which was good. There is a big difference between the standard and this chip, such a difference that my 10year old daughter comment was how smoother the car felt, and she is right. Remember...

Hi bodger,
I am looking to do the same, at the moment i don't know my ratio as the tag is all rusty

I am interested to know what is your speedo speed, when your rpm is at 3000 in 5th gear

Mine is at 70 mph, (my tyres are 205/55 15")

i would be good to know the same from other zoners as well.

i have test mine with my talex and OBC form 30 and upwards, the Speedo was constantly 5 mph less. also non standard wheels doesnt explain the difference between the speedo and OBC... do they run from the same speed sensor? and am i right in thinking this is in the diff casing? I would presume the sa...

Frequency generator oh yeah I have one those sitting on top of my wardrobe It was something I put together when I was studying electronics, now I just have to build a power supply for it then I can try this recalibration business. Ibriggsy regarding cameras I this from gov site Ã¢â‚¬Å“ National guid...

I have had 3 E30's and they all did the same the speedo is out by 5 mph,I have a Talex GPS Camera Detector ,which shows the correct speed as with the OBC. This is why all speed cameras are set with a approx 10 % leeway as the majority of analogue speedo are not accurate. this means you can do 45 mph...

To achieve such high speed ,shouldn't the final drive ratio be consider aswell as power, check this link it allow you to calculate the speed with different final drive. http://pw1.netcom.com/~sgalaba/mph.htm My wheels are 205/55 15" if was to change my diff to 3.45, in 5th gear I should reach about ...

try the Auto trader i paying less than 400 for my 325 sport

1 . Cotty 2 . Gazza325cab m3 3 . essexboy 4 . tylerma 5 . 1an 6 . 12345kevin 7 . DRIFTBOY 8 . dips346 9 . Theo325 10 . Oguz327 11 . d6dph 12 . gareth 13 . spook 14 . mattG 15 . mincedbeef 335i cab 16 . Smithy318i 17 . DANGEROUSuk im in 18 . tom325sport 19 . Ant 20 . HartgeH27 21 . Ste 22 . DelaneyG ...

Search found 26 matches

Re: Prop shaft, vibrating? how to remove?

Re: Chips!

Re:

Re: chip tuning?

Re:

Re: chip warning/advice...

Re:

Re: any zoners in the harrow area (middlesex)

Re:

Re: on board computer bulb

Re: Yet another water leak. HELP!

Re: Changing 2 pc Exhaust System

Re: Changing 2 pc Exhaust System

Re: Help needed, I'm losing out to a Subaru!

Re: Changing 2 pc Exhaust System

Re: what would you do

Re: Changing 2 pc Exhaust System

Changing 2 pc Exhaust System

Re: Speedtouch +++

Re: low ratio diff

Re:

Re:

Re: Speedo UnderReading

Re: 190mph? Possible?

Re: Insurance

Re: