E30 Zone

It lives !! :banana: Had a good read around night before and went back with a fresh head and ideas .. First thing I come across while on the net was C191 plug .. didn't recall plugging or seeing that .. Found it was the loom for the injectors. Had a look and it wasn't plugged in :o: , completely for...

Ill have a read through wiki mate, knowledge is good :) Hoping it something as simple as been flooded, just after a long tiring day, putting engine in and plumbing it in amongst other issues, I don't tend to think straight/logically at end of day :roll: Will have another crack at it after work and t...

After trail and error, I've got fuel pipes in that configuration. Thanks for confirmation on that.
Any other things to check ?
Would the c101 plugs match or do I need swap any wires ?
Is it possible have fuel and spark and no fire?

Hi all, got a slight issue with a engine swap. Put m20b25 lump out of a H reg into a G reg 1.6 . Car turns over fine, fuel is flowing, there is spark. But no fire. Not even a splutter :? Thought this is all that was required to fire ? Have had engine in bits while was out, mainly cleaning it, timing...

Found a little problem today, the "fuel damper" ( think that's correct name ) which comes just after the fuel pump underneath had three pin holes due to rust and was losing quite abit of fuel at this point. Have removed this and just connected fuel pipe up. Have got a booster pack on too, car splutt...

Ok that explains the vacant pin 15. Does it seem like I've got starter from a facelift on mine. Had another set of eyes to give it a look over. Don't ask, ( was having a brain fart day ) but I do have spark :roll: Should have mentioned this earlier I guess if it helps... :roll: Engine while removed ...

Plot thickens :roll: Had another look at starter today after removing it noticed that I had the smaller/thinner wire on the wrong lug on starter :o: Didn't notice the lug on bottom as couldn't see it. So now car turns over, fuel looks fine, just doesn't seem to be a spark? Is there some wiring issue...

Yes has the C101 ..

Shell loom Pin 15 has nothing. Pin 18 is Black/Yellow

Engine loom Pin 15 has nothing. Pin 18 Black/Yellow

Does Pin 15 need wiring ?

Thanks

Wires I checked and look fine. Took photo before removing them and look the same configuration.
Engines is 2.5 from pre facelift mate D reg cab.

Everything you mentioned is there. All fuses and relays are in place. When trying to start car from ignition the replays click and that's all. The starter does not turn at all. When shorting the starter out ( screw driver method ) the starter spins. Its like the starter is not engaging. Just off the...

Brianmoooore thanks for the help

Got it sussed and found the wiring already there too ( wasn't looking hard enough )
Will I need to add a relay / fuse for the fuel pump ? As it is pre wired already.?

Thanks again

I'll get new handbrake cable ordered tomorrow. The disc setup has flexible pipe from arm to caliper in place. ProbAbly replace these too for peace of mind. Not looked at it in while so seeing it will make more sense I guess. Just didn't want to tackle it and find I'm short of a pipe or something hal...

Thanks for the info Brian... Just to clear it up, having a slow day sorry, I'm going to remove the second pipe along with the fuel pump from doner car and is it just a simple matter of putting pipe in and fuel pump and just plumb it together ? The shell tank doesn't have cup in the tank either. Thanks

Swapping out rear subframe/axle from one with drums to one with discs. Handbrake cable and brake pipes have been chopped on subframe with discs to go onto car. Replacing subframe bushes and rtab at same time. Can handbrake cable and brake pipes be used from the drum setup onto the disc setup? It is ...

Hey all .. Got hold of a very clean coupe shell its an E reg. I believe it was 1.6 originally ( I got shell without engine ). Looking at dropping M20B25 into it. Just looking round noticed there is only on fuel pipe coming from rear of car to the engine bay :? Would this be because it was originally...

Thanks for quick replies guys ..
These are the seats in question

Cheers

Im probably been blind and cant find any posts regarding my simple question ..
But leather interior, is there a away of telling if the rear bench is from a coupe or convertible by the way stitching runs ( horizontal or vertical stitching ) ??
Thanks

Wtffffff is that ... Nice skills as mentioned but gone to waste on that ..

Search found 18 matches

Re: M20B25 swap not starting

Re: M20B25 swap not starting

Re: M20B25 swap not starting

M20B25 swap not starting

Re: Fuel pipes .. puzzled

Re: Fuel pipes .. puzzled

Re: Fuel pipes .. puzzled

Re: Fuel pipes .. puzzled

Re: Fuel pipes .. puzzled

Re: Fuel pipes .. puzzled

Re: Fuel pipes .. puzzled

Re: Rear axle swap

Re: Fuel pipes .. puzzled

Rear axle swap

Fuel pipes .. puzzled

Re: Seats Coupe or Convertible ?

Seats Coupe or Convertible ?

Re: Custom E30 Looks Wicked :P