E30 Zone

Thank you chaps”¦ i will have a good look this weekend and report back if I'm stuck! Thanks again

JP

Afternoon all”¦. my e30 has been running well for some time, and i recently changed the coolant, which hadn't been changed for some time, ensured there were no air locks etc”¦ but i have now woken up to a drivers side footwell full of my new pink coolant! its dumped pretty much the whole lot, so i h...

If you take the casing off around the fans and they are running freely i would consider cleaning or replacing the resistor pack”¦.

I meant the unit which has one dark coloured and one light coloured fan on either side. only one was going around. But thats great thanks”¦ Mines a pre-facelift model so would i be looking in the same area. As alway thanks for you help.

Update - i realise the blowers do actually fit out, so they just lift out in to the engine bay and i think the resistor is just underneath the blowers and can be replaced easily. Feedback on if anyone agrees it sounds like the blowers and resister, due only getting a live when heater on setting 4 on...

Hi, right so found the connections.. Linked fans directly to battery, one of the fans whirred around briefly but only for a couple of seconds, now nothing. Fuse okay, have checked for a live from the wires and only get a live when the fan is switched to 4.... Nothing on 1,2 or 3?? And when on 4 fans...

Great will give that a go. Thanks

Hi all. I turn my heaters on, hot or cold and get nothing at all.. Completely dead. I have changed the fuse and the relay works fine for the other units it supports.. But literally get nothing if I turn the fans on.. I would test to see if live is going to the unit but not sure what wires I'm lookin...

Hi Andy, I have recently gone through the same thing... I have bought other cabby wings.. Bloody expensive!! And still they are all somewhat corroded and can't help but think they will only last so long... My opinion is as follows... Worked great for me... I bought some new front wings for a 2 door,...

Hi all. I have the coolant warning light on the overhead panel which is constantly on.. My heating also does work... Nothing at all when I turn heaters on.. Is it linked? If so any suggestions? I changed radiator etc recently but also wasn't working before .. Any suggestions appreciated.. Thanks

Perfect thank you. I had a duff clock.. A small think wire layer had broken off the solder inside. Just re soldered on and working perfectly. Thanks again for you help.

Yes 21 replaced and boot light was working too.... May well be the clock... Unless anyone can tell me what the four props are for... I noticed a lab,e on one of the wires supplied to the light had been labeled so someone has had a fix on it before... Thanks

Hi, my clock in the front isn't working... The backlight works okay and out of the four prongs out of the unit one is live... All the others I have no power but can find what these four represent... 2 live and two negative? One for light and one for the clock?? Any help much appreciated as have no i...

Thank you

Aftermarket... Have changed them with OEM.. Same order and running sweet!! Thanks... Must have been an old or faulty or loose lead... ?! Thanks for help

Yes, I marked them up before changing.. But will double check if I can find a diagram somewhere! Thanks

Ht leads! Predictive txt!!

Being resprayed.. Sorry!

Hi all, I have a 325 1987 cabby and engine was running pretty good but I have had in apart being respected for almost a year... Before I restarted I replaced the hot leads and plugs and have now driven it home but have a massive loss of power.. It has no gutts at all and feels like a big loss of com...

Hi, I have just gone through this and to be honest, for under 50 quid you could have the whole lot powder coated.. There is a relatively common match which is the exact shaddowline colour.. This way they would be properly prepped and baked and they set hard so there will never be any paint removal, ...

Okay thanks.. Thought maybe that was the easiest way. Much appreciated

Hi all.. I'm looking to strip the chrome trim for the horseshoe guttering for my cabby as Bmw are no longer making these! The rest of my car is now shaddowline so I have bought some hydrochloric acid and had it in this for 2 days and the chrome hasn't budged!! I'm begining to realise maybe it's not ...

perfect, thanks very much

Sorry.. I'm changing from the 'early lights' rather than bullseye as originally stated.. Thanks

Hi.. I have a set of pre 87 lights (bullseye) which I'm swapping from some post facelift ones”¦ are you interested in second hand ones”¦? i enquired with BMW too and they were £427 quid to replace so went for some new, aftermarket post facelift lights”¦ let me know if your interested or if that will...

Hi all, just wanted to confirm the change on lights”¦ I'm changing from the 'bullseye lights to a post facelift headlight.. so my old ones have a connector with 3 prongs and 2 on the other light and the new ones have just 2 on each light”¦ Do i try and find a plug to fit the new ones with a bit of w...

Yes I did mean pre to post.. That's perfect thank you. presumable the frames will fit no problem. . . Thanks again.

Hi all, I have a 1987 pre facelift cabby with the early bullseye headlights.. Can replace them to new lights without spending a fortune on OEM and wondered if I could use an aftermarket replacement for the later models? The loom on my lights have a three and two pin set up and the think the new ones...

Hi all, i have a pre facelift 1987 Cabby and its just being re-sprayed etc and looking for some new headlights, ideally smoked.... i can only find facelift versions... any ideas on where i may be able to buy some? If not some clear ones but not Angel Eyes.... Thanks in advance

Thanks very much chaps. Great advice as always.. Again any suggestions on a good or recommended make of dampness .. Thanks again

Hi guys.. I'm just putting some 17s on my newly sprayed 325 :) and really only looking to fill the arch so need to lower the car a little.. I'm not looking at dropping it to the foor, I imagine 40mm max.. No totally sure.. But could I just replace the springs or should I replace the shocks too.. ? I...

Thanks so much.. Really appreciate your help..

Cheers... I want them but unless your relatively close to me (Somerset) I can't fees able collect.. So can u send?!

If I'm to buy normal ones and weld a plate - which ones do I buy? Peter will PM you

Thanks guys.. So much appreciated.. Do I need go get the wings from a 2 door or are all the other wings the same? Thanks you

Search found 55 matches

Re: Coolant in Footwell - Help with Matrix please!

Coolant in Footwell - Help with Matrix please!

Re: Heater fan not working

Re: Heater not working, nothing from blowers etc - please he

Re: Heater not working, nothing from blowers etc - please he

Re: Heater not working, nothing from blowers etc - please he

Re: Heater not working, nothing from blowers etc - please he

Heater not working, nothing from blowers etc - please help!

Re: Cabriolet front wing/fender rust

No heating and coolant light?

Re: Clock not working. Please help!

Re: Clock not working. Please help!

Clock not working. Please help!

Re: Loss of Power

Re: Loss of Power

Re: Loss of Power

Re: Loss of Power

Re: Loss of Power

Loss of Power

Re: What paint is closest to the OEM shadow lone?

Re: Strip Chrome for shaddowline.. How?! HELP!!

Strip Chrome for shaddowline.. How?! HELP!!

Re: Old to new headlights wiring, please help!

Re: Old to new headlights wiring, please help!

Re: New Headlights

Old to new headlights wiring, please help!

Re: Changing headlights

Changing headlights

Where can i buy new pre facelift lights?

Re: Lowering advice

Lowering advice

Re: Cabby Side wing alternative?

Re: Cabby Side wing alternative?

Re: Cabby Side wing alternative?

Re: Cabby Side wing alternative?