Or how about their 6 branchs has any tried one of them in RHD ?

Yes please I
i would like the full set front and back if poss

Caster and Steering Axis Inclination + rear setting if poss
many thanks

Hi , i m after a std m3 suspensions settings
, i ve just fitted eccrentic wish bone bushs and may later fit the m3 top mounts
and want to set the front suspension to m3 spec , any one got them ?

Hi Does any one know what the std fuel pump on a 1990 320 cady can support power wise , and are they the same as fitted to a 325 ? Reason is preping for 2.7 conversion with Nos , hoping to run 75 bhp then up to 125 + if ring lands will take it , but will i need to uprate the pump ? if so any comon u...

Thanks all
lucky ive got a complete 325 to use if i decude to strip it out

Need advice as to any set up required for a FSE REGULATOR , got a second hand one but no set up instructions , 320i 91 caddy Also are there ant differences in a 320 to 325 gear box ie ratio s etc as mime wining in 3rd and 5th but have got a ETA engine to swop once built up with my 320 head so was th...

Yep, 1 st tryed pushing the metal wire clips in , ie to wartds the inlet m/fold , like the cold start injector , then found that they release if you, can get a sharp srew driver behind the clips and pull it towards head , but only managed a few this way ? thanks for replies any way , sounds like the...

ok i want to remove the injectors , i started and manged to get 2 of the electrical clips after a bit , but could not get any of the others , is there a tip , or special tool needed ? it seems that u have to get the elctrical connectors off 1st so u can get the bolts out from the fuel rail?

Thanks for advice Done most of that , can alter micro switchs and set start & stop limits ok . I can set up the micro switchs and get the lever starting /stoping ok , but it works ok ONLY if the up or down buttom is kept pressed all the way thought a complete cycle But what i am trying to do is to s...

Hi HELP! Has any one got a copy of the wiring diagram for 91 320 caddy ? i fitted new hood motor ok and can set it up to work ok but only if you keep your finger on the open or close button for the full cycle . if you stop it and restart it haft way though , the motor lever over travels , (ie into t...

Thanks for comments just ordered new drive rods Ԛ£Ã”šÃ‚£Ãƒ”šÃ‚£Ãƒ”šÃ‚£Ãƒ”šÃ‚£ Can any one confirm what the s1 and s2 adjusters / micro switchs do s1 does ? s2 does ? n the rhs hood motor, i belive they alter the movement in degrees on the drive arm ? I really need a set up procedure to continu...

Dave D / any one help? I swopped the motor over ok , used your reset procedure ok (many thanks ) but got problem setting up linkage drive rods, i believe it may be main hood rod is bent to much, i got it working on sat , but not to day , think rods bent with to much use? is it a fail safe or common ...

Hi very interested
as all ready run 200bhp octivia turbo on lpg , its great
and got the e30 planning to convert it
where in the country are u thinking of doing this ?

Many thanks will give it a go this week end
In Darford so will have to try it my self
cheers

Hi i 'm replacing the power hood motor on my cady, ( cracked casing )
before i fitt the new motor , is there any set up procedure for resetting the cabin hood to frame lift motor , and adjusting the drive rods/ linkage?

cheers