I've just purchased an e30 and it has rust in the sunroof panel and in the cassette. My plan is to remove the whole cassette and sunroof panel to prevent any further issues. What have others used to fill the hole? I don't want to have to paint the roof so welding is not an option. My plan is to take...

Thanks I found other threads on here and now it runs! All I did was plug the two yellow/black wires together and it fired up. Do I need to remove the inhibit relay and loom or can I just leave it in there???

Hi, Ive carried out a manual conversion on my car and I cant get my head around the wiring on the neutral safety switch. Everything I have read has told me that I need to join the green/yellow wire to the two green/black wires and just tape the brown one back. My issue im having is I dont have a gre...

Ive got an 82 323i e30 here in New Zealand. No side repeaters, No power steering, No air-con

Are those rx7 batty seats in the caged car?

Tourings have 51mm ones but they could have been changed at some point. Just measure them

So the old ones and the new ones arnt interchangeable? What abot the fuel guage coding plug? ive got a cluster out of a S.A e30 with the long range fuel tank and the guage reads the wrong amount compared to the U.K guage

What one is the coding plug?

They will fit if you have 45mm struts. I have them on my E30.

Ive got


1987 E30 320i race car- Inka Orange

1985 E30 323i Daily its abit rooted but it gets me from A to B haha

1958 BMW Isetta 300- Under resto at the moment

Can someone please explain what it is and why its a hassle when doing an m50/52 convertion?

Clutch Release bearing mate. Nothing to worry about

Im keen to hear how this goes

In the New Zealand e30 class i compete in the best engine package is a p/fl bottom end and the f/l top end. This gives you the best compresion and the best injection setup

The p/fl uses jetronic injection and the f/l uses motronic on the 320i. All 325i's use motronic though.

My e30 has developed a misfire recently. I replaced the distributor rotor about a month ago as it got a hole burnt through it and that fixed the problem. But the misfire came back so i pulled the dizzy cap off again ind it turns out that the point that gives power to the rotor arm has been burnt awa...

My 323i did the same thing and it was the distributer rotor..