I would be carefull with tie wrapping the pump to the cradle as petrol does melt some plastics
and the residue aint good going through the fuel system !

Ok thanks i will contact you soon.
Recived the short shift kit today, cheers

The car has discs im looking for the back plates that house the handbrake shoes etc.Thanks

Its not a mot failure it would be if it was the outer because grease can get onto the disc .still needs doing but not so urgently

Yes spage you do reconise the shell

Im not that much smaller. I was going to fit a cosworth lump i did has escos for a few years running 400 bhp
I know them inside out but it was a costly expirence !

After getting the rolling shell at the beginning of the year I have finally finished putting the m30 lump in and sorting a few other things out. It has taken me a while due to work and family commitments. So far I have: fitted m30 engine used .ie mounts 535 radiator Rs turbo fan (from my old ford da...

Thanks for the info i wiil source another gauge.

Hi had a look today my car doesn"t have a sender under the left hand inspection plate

HI the gauges in the car are the original ones unless they have been swapped before i got the car.

Dont know if the fuel gauge worked properly before i did the swap as the car had no engine in it when i got it. The gauge shows half full but the low fuel light is on. When i put more fuel in it the gauge goes up and the light goes out and when the level drops to half the light comes back on.I have ...

Well the head lights i got had seized and broken adjusters the clips that mount the lamps where broken and
they took nearly a month to turn up.
I have sent whispey a pm to explain this but he ignored me

Waited nearly a month for him to post parts out.
When i got the it was i load of junk.
Not good !

Hi with regards to a small turbo engine (t25) its better to use a marelli loom and ecu set up( from any saff cos or a new pectal loom ) its a better setup and alot easier to get 350+ bhp and also the engine looms in a escos are built into the full car loom and would be a pig to separate

Thanks for the reply so if its 10 cm long i still have plenty left in then.

Hi all im a newbe on here. Im just in the middle of doing a a 3.5 swap (acually im doing 2 mine and a guys on here called milko). I have had my prop cut and welded .I have fitted it but i had to extend it out on the centre spilines. I have about 35mm of spline showing its out 10mm more than it was. ...