Lowerd 4 Door 60/40, Rear looks too low?
Moderator: martauto
Ive not got any pics yet but Ive lowerd my 320 4 door 60mm front and 40mm on the rear with 15" x-spoke alloys but the rear looks to low, seems like its lower than the front?
Anyone got any pics of lowerd 4 doors so I can see what rear springs I need.
Anyone got any pics of lowerd 4 doors so I can see what rear springs I need.
Go to my past posts via my profile and look for 'the moordoor' in gallery section, mine is set up 60/55 on 15's...
Last edited by sunnyr83 on Wed Aug 11, 2010 4:08 pm, edited 1 time in total.
I think you must have been sent 60mm rears as well. This happened to me with jammex springs back when I knew no better.
60,40 sits perfect for a facelift with the backs looking level.
Pics would help if you could get them mate
60,40 sits perfect for a facelift with the backs looking level.
Pics would help if you could get them mate

Co Founder of CR24vTM By Invitation Only. Absolutely no riff raff!!!
On a facelift?/// KAMI wrote:iv got 50 at the front and 60 at the back looks spot on....
It can't look spot on as the front will defos be higher than the rear.
Are you going for the speed boat look?

Co Founder of CR24vTM By Invitation Only. Absolutely no riff raff!!!
Ill get some pics ASAP
It is a face lift, It is sort of level! if you mesure from the floor to the bottom of the seal at the front its the same as the rear but looking at the car it looks lower at the back, but that could just be the arch level?
It is a face lift, It is sort of level! if you mesure from the floor to the bottom of the seal at the front its the same as the rear but looking at the car it looks lower at the back, but that could just be the arch level?
They are defos 60/60 springs IMO.
The sill will be level but with the rear arch being lower on the facelift it looks lower at the back.
The sill will be level but with the rear arch being lower on the facelift it looks lower at the back.

Co Founder of CR24vTM By Invitation Only. Absolutely no riff raff!!!
It is more common to have the wrong rear springs in a kit.
A 40mm rear spring can not make the front still higher if you have 60mm on the front.
When you see a 60mm rear the tyre is in the arch with 40mm there is about 1/2" gap between tyre and arch.
Unless like above the subframe bushes are fooked.
A 40mm rear spring can not make the front still higher if you have 60mm on the front.
When you see a 60mm rear the tyre is in the arch with 40mm there is about 1/2" gap between tyre and arch.
Unless like above the subframe bushes are fooked.

Co Founder of CR24vTM By Invitation Only. Absolutely no riff raff!!!
-
aaronsmart
- E30 Zone Regular

- Posts: 822
- Joined: Fri Dec 18, 2009 11:00 pm
- Location: Bournemouth

thats a 65/50 drop
i want the front droped alot more though

What size tyres/wheels you running aaron? looks more like a 40mm drop all round!!
BMW E30 344i track car 
BMW F31 335d xdrive
BMW F31 335d xdrive
Possibly 50mm at rear and 40mm at the front from the pic.charlE30 wrote:What size tyres/wheels you running aaron? looks more like a 40mm drop all round!!
Mybe you could try the -15mm gophers in the for sale section. I have them fit to my 35mm H&Rs for perfect ride height on my chromie and no sacrifice of ride quality.

Co Founder of CR24vTM By Invitation Only. Absolutely no riff raff!!!
-
oldroydsr4
- E30 Zone Squatter

- Posts: 1579
- Joined: Tue Oct 25, 2005 11:00 pm
- Location: Warwick
IMO for the perfect ride height on an e30 you have to make a big compromise on ride quality.
But who cares.
But who cares.
i have a chromie and its got the speedboat look going on, just ordered 60 on front and 35 on back, the back is slightly low already cuz of a bass box. jus hope the front dont look too high cuz of the weight from the back.
Looks ok to meDezzy wrote:On a facelift?/// KAMI wrote:iv got 50 at the front and 60 at the back looks spot on....
It can't look spot on as the front will defos be higher than the rear.
Are you going for the speed boat look?

THE ULTIMATE DRIVING MACHINE
-
B7
- E30 Zone Team Member

- Posts: 15846
- Joined: Tue Feb 13, 2007 11:00 pm
- Location: Surrey / West Sussex
If the rear beam bushed are fooked, it will sit up to 10mm lower than it would do with sound ones. My convertible was on it's arse and the bushes were shot.
B7's Motto. "If it's French, BURN IT!!!!!!"
Kami , Got any pics of how yours sits from the side ?
As cant see how 60 rear and 50 front will sit ok
Usual is 60 front and 40 rear for a levelish look on a facelift i believe
And 60 front and 60 rear for a dog wiping its arse on the carpet council. look
As cant see how 60 rear and 50 front will sit ok
Usual is 60 front and 40 rear for a levelish look on a facelift i believe
And 60 front and 60 rear for a dog wiping its arse on the carpet council. look
Giggety Giggety Goo!!!
How can anyone see from that pic?/// KAMI wrote:Looks ok to meDezzy wrote:On a facelift?/// KAMI wrote:iv got 50 at the front and 60 at the back looks spot on....
It can't look spot on as the front will defos be higher than the rear.
Are you going for the speed boat look?

Co Founder of CR24vTM By Invitation Only. Absolutely no riff raff!!!
-
shedrool83
- Old Skooler

- Posts: 4395
- Joined: Thu May 10, 2007 11:00 pm
- Location: Dundee Scotland
[quote="Dezzy"][quote="/// KAMI"]iv got 50 at the front and 60 at the back looks spot on....[/quote]
[quote]im not sure what drop it is i think it is 55 at the back and 60 at the front.....[/quote]
You have no idea what you have. Your input isn't helping at all.
To me it looks like a 60,40 drop.
[quote]im not sure what drop it is i think it is 55 at the back and 60 at the front.....[/quote]
You have no idea what you have. Your input isn't helping at all.
To me it looks like a 60,40 drop.

Co Founder of CR24vTM By Invitation Only. Absolutely no riff raff!!!
Heres mine with a 60/55mm drop on 15's. Think it looks level to me.


Car sits level but the rear wheel is much further in the arch which gives you the speed boat look.
Not my favourate on a facelift. Just my opinion though
Not my favourate on a facelift. Just my opinion though

Co Founder of CR24vTM By Invitation Only. Absolutely no riff raff!!!
Oh right is that whats meant by the speedboat thingy..was getting confused . Ta
mine has the gap at the front aswel (speed boat look )... i was woundering out off all the springs on the market which ones sit the lowest ie jamex..apex..h&rs etc... (60mm of course)
Has any one experienced any low springs for the front (with minimal gap from arch to tyre) as im going to have to slam the front soon.
p
Has any one experienced any low springs for the front (with minimal gap from arch to tyre) as im going to have to slam the front soon.
p
- CpnSpankyPantz
- E30 Zone Regular

- Posts: 373
- Joined: Tue Sep 22, 2009 11:00 pm
- Location: Down South
Not a 4 door, but mine on a 60/40 drop:











