dc2100k's Rolling Parts Required List
Posted: Thu Jun 25, 2020 5:40 pm
I'm trying to source a bunch of parts for my road rally car build (1990 318is in Diamondblack). My car is missing a load of stuff (including the entire drivetrain!) which I'm hoping to pick up over the next few months. I've separated these into Exterior/Interior/Drivetrain and i'll update this thread as I find more bits I need! I'm not going for originality or a concours build so used, cosmetically challenged and non-standard/aftermarket bits are fine in many cases.
EXTERIOR:
318is bootlid badge.
Rear Bumper mounting hardware – N/S sliding clip & both rear valance brackets.
Full screenwash system, Anything considered inc. the boot mounted Touring setup
INTERIOR:
2 door rear seat base and back, anything considered.
Roll Cage, anything considered.
Reclining bucket seats on E30 subframes/mounts, anything considered.
DRIVETRAIN:
Front brake discs and callipers for 318IS struts. Would consider BBK (Corrado discs, RX7 callipers?).
Fuel tank, pump, sender setup; either standard or an aluminium fuel cell system.
I'm also looking for an early E36 318IS or 318TI as a donor for the entire drivetrain if anyone knows of anything?
Cheers.
EXTERIOR:
318is bootlid badge.
Rear Bumper mounting hardware – N/S sliding clip & both rear valance brackets.
Full screenwash system, Anything considered inc. the boot mounted Touring setup
INTERIOR:
2 door rear seat base and back, anything considered.
Roll Cage, anything considered.
Reclining bucket seats on E30 subframes/mounts, anything considered.
DRIVETRAIN:
Front brake discs and callipers for 318IS struts. Would consider BBK (Corrado discs, RX7 callipers?).
Fuel tank, pump, sender setup; either standard or an aluminium fuel cell system.
I'm also looking for an early E36 318IS or 318TI as a donor for the entire drivetrain if anyone knows of anything?
Cheers.