sump swap
Posted: Thu May 29, 2014 7:07 pm
just swapping the sump over i just want to double check the bracket on the tray i need to cut off right? and keep the tray in not remove it.
cheers
jon
cheers
jon
Page 1 of 1
Re: sump swap
Posted: Tue Jun 03, 2014 7:16 pm
anyone?
Re: sump swap
Posted: Tue Jun 03, 2014 7:46 pm
bend the bracket back and forth a few times and it will snap off. I still have the windage tray in my S50(US)e30
Re: sump swap
Posted: Tue Jun 03, 2014 7:48 pm
Yep bend or cut the bracket off with snips, best to not use a grinder with an open sump.
Leave the tray attached
Leave the tray attached
Re: sump swap
Posted: Tue Jun 03, 2014 9:29 pm
sweet cheers guys 
Re: sump swap
Posted: Sun Jun 15, 2014 11:21 pm
I have the bracket attached under the Main Bearing bolts, i have now removed it completely, will i need to replace the Main bearing bolts i have removed?
At this point I have also been advised to weld the pump sprocket bolt onto the sprocket as these are prone to come loose, is this needed?
At this point I have also been advised to weld the pump sprocket bolt onto the sprocket as these are prone to come loose, is this needed?