Page 1 of 1
Heater Blower Motor
Posted: Wed Apr 23, 2014 10:39 am
by Hopchop
Does anyone know is it possible to get at the heater blower motor with an M52B28 engine fitted as it sits right up against the bulkhead?
Re: Heater Blower Motor
Posted: Mon Jun 15, 2015 9:05 pm
by JamOnIt
Did you get anywhere with this problem as I need to change my heater resistor?
Thanks
Re: Heater Blower Motor
Posted: Tue Jun 23, 2015 6:11 pm
by Brianmoooore
WillNZ wrote:Should not be a problem to remove the cover hiding the blower motor and getting it out to service it. You will probably have to remove the plastic manifold cover to make life easier.
IIRC, the lower left screw is difficult to get at, and is best replaced by a steel tab that hooks over the bulkhead to hold that corner in, and just refitting the other three screws.