Page 1 of 1

Need some advice.. m30 crank hub damage.

Posted: Tue Jun 24, 2014 2:27 am
by kewliost
Okay so Ive had the slowest m30 conversion in history, but i got keen and was getting stuck back into replacing seals on the motor when i found this..

Image

Image

Is this fatal?

I cracked the flywheel bolts by sticking a screwdriver through the auto flex plate to lock it in place would this have caused the damage?

Its pissed me off a fair amount, the engine has had head gasket and work done to the top end before i got it so its squeaky clean in that regards.

Re: Need some advice.. m30 crank hub damage.

Posted: Tue Jun 24, 2014 8:48 am
by rob0r
Oh my, if that was holding my flywheel and clutch on I'm not sure I'd take the risk.

Re: Need some advice.. m30 crank hub damage.

Posted: Tue Jun 24, 2014 9:37 am
by zaust
As above get it swapped.

Re: Need some advice.. m30 crank hub damage.

Posted: Tue Jun 24, 2014 10:12 am
by kewliost
Im thinking of finishing the car and driving it whilst looking for a replacement engine to come along.. i've got all the parts for the conversion, replaced all the seals i could think of on this motor and then get to basically the last seal to do and find this..

Posted: Tue Jun 24, 2014 11:53 am
by jmc330i
Its not a risk I'd take... Imagine this happening next to your legs/feet 8O

Image

Re: Need some advice.. m30 crank hub damage.

Posted: Tue Jun 24, 2014 11:53 am
by rob0r
Think where your flywheel is parallel too... I like my feet! I seriously wouldn't