E30 Zone

Any one able to quote me for some ali work?

I need a 'top hat' with a base diameter of 125mm

then a 50mm hole in the middle.

then a 50mm high bit ontop ala this rough sketch




Only needs to be thin aly its just to seal the back of a head light unit, sadly need the top hat bit to hold the light connector.

Do you not see the problem with that request ?

hi yes i could do these for you. pm me on quanity and any other details.
regards nigel.

Need to varify thickness of raised section. 50mm raised section vs 50mm = 0....

wait.... nevermind. It's not en engineering drawing. I read it verbatim and... I'll get my coat lol.

Can you explain what you mean so I know lol

I think I was talking bollocks. Misread the sketch, sorry.

I interpreted it as a top hat shape with the raised section as being 50mm in diameter. Imagine a hole 50mm too. You can see where I fell off the track lol.