was thinking about building a drift spec car. so bought an e21 320/6 for mucho cheapness few months back. ive been busy doing this and that on it since. done all the brakes, cambelt+water pump, stripped and cleaned the carb, stripped it out etc.
the whole car is quite rotten in places, me and my mate tom (whos my partner in all this) started the weldathon. ive done build thread on trampdrift.com but i thought id put some pics up on here too see what you think........
rust damage to rear axle mounts
n/s
o/s
holes in the boot/inner arches
repairs in progress
back axle painted and diff welded
finished and done
back together
also cut the spare wheel well out
replacement panel made
and plug welded in and painted
put fuel lines and brack pipe thru the car
bit of other work inside too
back running but still needing more welding in the front foot wells and behind front wings but alot further along than it was.
skids well too!
thats where were at so far. going up there tomora to get some more done.
any comments welcome!
Looks fun!
