E30 Zone

hi guys has anybody done this as i want to but not to sure how to go about it??

i have a pull/ motorised screen that i wish to fit here, and it has a seperate din sized dvd player which i will fit in standard slot. so all help would be great???

cheers jamie

try this website
www.mp3car.com

you will be better off fitting the head unit lower down in the center console just behind the ash tray and put the dvd where the head unit would have been as the vent size is much bigger then din size but you can make a face for it .
you will also have to block the venting behind to stop heat getting in that area

The center vent is held into the dash by 4 plastic flanges.
2 large ones on top and 2 smaller ones on the bottom.
The best way to remove them without damaging the dash would be to remove the dashboard and push it out from the back.
If you cant do that (or are unwilling) the plastic clips are 5.5cm from the center on the top and bottom. You might be able to insert a screwdriver into the radio hole and lever it out from the bottom.

cheers for the help guys.

dips346 wrote:you will be better off fitting the head unit lower down in the center console just behind the ash tray and put the dvd where the head unit would have been as the vent size is much bigger then din size but you can make a face for it .
you will also have to block the venting behind to stop heat getting in that area

fitting behind the ash tray area seems a good idea. is it simple to cut out a din slot in the plastic or are there things behind to watch out for?? as i would like to cut it out in place??

jamie

beemer_jay wrote:

dips346 wrote:you will be better off fitting the head unit lower down in the center console just behind the ash tray and put the dvd where the head unit would have been as the vent size is much bigger then din size but you can make a face for it .
you will also have to block the venting behind to stop heat getting in that area

fitting behind the ash tray area seems a good idea. is it simple to cut out a din slot in the plastic or are there things behind to watch out for?? as i would like to cut it out in place??

jamie

very simple you only need a knife ,loads of room

cool cheers dips

behind the ashtray is the best place for it mate..but i like smithy,s idea of putting the head unit up there in the vent.. i can see that being the springtime project for the sport..if i ever get the paint job finished

Dips.. like the new sigpic.. leaves the door open for my white/blue combi

i fitted a stereo down there in my 320 i had several years ago as it was one of the first kenwood masks without the removeable faceplate. fitted it in the centre console and made a vinyl covered plate to disguise it from the scrotes who tried to remove it from my previous car.seem to remember making a frame to space it forward a little too for some reason.

just a point but if you have aircon dont break out the stanly knife cause you will have a bigger heater box and i dont think the radio will fit.

gra325i wrote:
Dips.. like the new sigpic.. leaves the door open for my white/blue combi

you still doing it

yeah dips..in the process of prepping the kit just now..far too cold for painting at the minute tho..its -4 up here tonight

There is an easier way to make one fit folks

Use the trim panel from a LHD car to allow the screen to power out without hitting the indicater stalk

BadDave wrote:There is an easier way to make one fit folks

Use the trim panel from a LHD car to allow the screen to power out without hitting the indicater stalk

he has din units to fit not just the one

dips346 wrote:

BadDave wrote:There is an easier way to make one fit folks

Use the trim panel from a LHD car to allow the screen to power out without hitting the indicater stalk

he has din units to fit not just the one

Should have read it more thoroughly

My apologies