e30 M3 front bumper ??
Posted: Mon Feb 06, 2006 8:51 pm
Would you be able to modify a e30 m3 front bumper to fit a e30 325i ?? and if so is it alot of work ? or could any half decent bodyshop fit it ? many many thanks in advance.
Page 1 of 1
Posted: Mon Feb 06, 2006 8:58 pm
No its not possible unless you got wide arches like the M3
Posted: Mon Feb 06, 2006 9:20 pm
nothings impossible, i bet a decent enough garage could carry it out. but dont think it will look right on a 325, or any other e30 bar the m3
Posted: Wed Feb 08, 2006 12:30 am
it possible and not too much agro,if its a post 88 car you need early spec front pannel and bumber irons, and the bumper will bolt straigh on, the only thing you will need to mod is the corners of the bumper, just pull them in a bit to sit flush with the wing.
Posted: Wed Feb 08, 2006 12:31 am
wrong!maxfield wrote:No its not possible unless you got wide arches like the M3
look above
Posted: Wed Feb 08, 2006 10:37 am
i have seen the bottem lip on a car, and that looks pretty cool. are you going for the whole m3 front? (bumper, valance, lip)
Posted: Wed Feb 08, 2006 10:37 am
Im sure I have seen this done somewhere on a touring. Have heard of peole doing this. Will try and find the pic that I have in mind.
Posted: Wed Feb 08, 2006 10:39 am
There we go. Think thats an m3 bumper?
