Page 1 of 1
Wheel size and offset question? 16x8's.....
Posted: Tue Aug 30, 2011 7:47 pm
by hammoj28
Looking to get a set of 8x16" wheels for the E30.
After doing a bit of research it seems a lot of people go for an offset of ET25 with these? Although I have seen ones with an offset of ET15. Would that be better?
With the offset of ET25 it seems people have to run a spacer, could I work round this and go for perfect offsets so I dont need spacers? Or should I just keep it simple and go for ET25 with spacers......
Was planning on Image as a supplier therefore I'm guessing I can have whatever offset I want within reason.
Basically, what am I best going for?
Cheers
James.
Re: Wheel size and offset question? 16x8's.....
Posted: Wed Aug 31, 2011 9:33 am
by Jhonno
Speak to Dan320is he has some 16x8's fitted.. I would run et15 personally, although the arches will need some love.
Re: Wheel size and offset question? 16x8's.....
Posted: Wed Aug 31, 2011 6:28 pm
by hammoj28
Dan, thanks for the reply, I would of gone for ET15 too.
I see Dan320is is running ET25 with spacers I think. Hmmmm. Cars getting painted so rolling the arches prob wont be a problem....
Re: Wheel size and offset question? 16x8's.....
Posted: Thu Sep 08, 2011 12:25 pm
by Stu_Bee
I have 16x9 with et 15, 205/40 tyres, 70/50 drop. The front arches are untouched but the rears needed rolling. I'm now running 215/40 on the rear and they needed even more tweeking to stop them rubbing.
Try this website:
http://www.willtheyfit.com/
Re: Wheel size and offset question? 16x8's.....
Posted: Fri Sep 16, 2011 4:00 pm
by stevie-p
I run 16x8 et10 on the rear on 205 45 16's arches are untouched atm and no spacers:

Re: Wheel size and offset question? 16x8's.....
Posted: Fri Sep 16, 2011 4:13 pm
by Rav335uk
8j's should ideally be ET 20 to ET18 and will fit without work
Re: Wheel size and offset question? 16x8's.....
Posted: Fri Sep 16, 2011 4:15 pm
by Jhonno
et15 and roll the arches the me old mucker..

Re: Wheel size and offset question? 16x8's.....
Posted: Sat Nov 26, 2011 11:57 am
by hammoj28
Thanks for the feedback guys, haven't been on for a while.
Hmmm, difficult to make a decision, ET18 would obviously be the safe bet then, no work and still sit quite wide, however i'm tempted in ET15 but then it needs arch work........
Need to be able to run decent size tyres too and not majorly stretched.
Re: Wheel size and offset question? 16x8's.....
Posted: Sat Nov 26, 2011 12:43 pm
by hammoj28